anslut 014511 Remote Power Switch Instruction Manual

anslut 014511 Remote Power Switch Instruction Manual

SAFETY INSTRUCTIONS

• Do not place two receivers too close to each other. The gap between two receivers should be at least 1 metre.
• Do not overload the receiver.
• Do not use the receiver near flammable liquids, solvent, paint or other similar products.

SYMBOLS

| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
| Recycle end-of-life product in accordance with local regulations.

TECHNICAL DATA

HOW TO USE

SYNCHRONISATION BETWEEN TRANSMITTER AND RECEIVER

1. Remove the small plastic tab from the battery on the remote control.
2. Connect the receiver to a power point. The LED indicator flashes on/off for 15 seconds or until the synchronisation is completed.
3. Press one of the buttons on the remote control within 15 seconds to conned the remote control to the receiver (learn mode closes automatically if no button is pressed). The LED indicator flashes three times as confirmation.
4. Connect the light to the receiver. Makes sure that the switch on the light is in the ON position.

Remove synchronisation

1. If the receiver is connected to a power point, unplug it. Unplug the light.
2. Connect the receiver to a power point. The LED indicator flashes for 15 seconds, or until removal is completed.
3. Press one of the buttons on the remote control within 15 seconds to delete the learned code (learn mode closes automatically if no button is pressed). The LED indicator flashes three times as confirmation.

TURN ON/OFF THE LIGHT

1. Press the button to switch on the light.
2. Press the button to switch off the light.

TROUBLESHOOTING

THE LIGHT DOES NOT GO ON

• The receiver LED is on
  • Check light source.
  • Makes sure that the switch on the light is in the ON position.
• The receiver LED is off
  • Check power source to receiver.
  • Try pressing the button on the remote control again.
• It it still does not work
  • Check the battery in the remote control.
  • Try synchronising the receiver with the remote control again.

Care for Enviornment

Recycle discarded product in accordance with local regulations.

EU DECLARATION OF CONFORMITY

Item number: 014511
Jula AB, Box 363, SE-532 24 SKARA, SWEDEN

This declaration of conformity is issued under the sole responsibility of the manufacturer
RECEIVER REMOTE: IP44

Conforms to the following directives, regulations and standards

This product was CE marked in year

Skara 2020-13-23

Fredrik Bohman
BUSINESS AREA MANAGER

Documents / Resources

| anslut 014511 Remote Power Switch [pdf] Instruction Manual
014511, Remote Power Switch
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>