logitech VR0029 Tap IP Meeting Room Touch Controller User Guide
- June 6, 2024
- Logitech
Table of Contents
TAP IP
Setup Guide
Guide d’installation
WHAT’S IN THE BOX
Tap IP Touch Controller| Documentation
FEATURES
1 – 10.1″ Touch screen
2 – Bottom cover with thumbscrew| 3 – Speaker
4 – VESA MIS-D 100 x 100mm| 5 – Motion sensor
6 – Factory restore pinhole
7 – Device reset button
BEFORE YOU BEGIN
You will need
- Meeting Room System Credentials/activation code
- Ethernet Cable(s)
- PoE enabled network OR
- PoE Injector and network (Ethernet or WiFi)
SETUP
Connect to PoE enabled network or PoE Injector (not included)
Assembly
Follow on-screen prompts to complete setup
FACTOR RESET
Press and hold
Pinhole Button for 5 seconds, press (B) Reset button, release (A) then release
(B)
www.logitech.com/tapip
www.logitech.com/support/tapip
© 2021 Logitech, Logi, and the Logitech Logo are trademarks or registered
trademarks of Logitech Europe S.A. and/or its affiliates in the U.S. and other
countries. All other trademarks are the property of their respective owners.
Logitech assumes no responsibility for any errors that may appear in this
manual. Information contained herein is subject to change without notice.
620-010671 004
Documents / Resources
|
logitech VR0029 Tap IP Meeting Room Touch
Controller
[pdf] User Guide
VR0029, JNZVR0029, VR0029 Tap IP Meeting Room Touch Controller, Tap IP Meeting
Room Touch Controller
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>