Guanyu GY-Z6E Wireless Charger User Manual

Guanyu GY-Z6E Wireless Charger

Notice: To ensure charging 3 devices safely and efficiently, you must use 9V/2A adapter and quick charge cable, If Including 15Wlast charging phones, you must use 9V/2.7A or 12V/2A adapter and quick charge cable (If not use the appropriate adapter and quick charge cable, the charger may not charge phone last, o「may not charge 3 devices simultaneously, or may even damage the charge

Product Appearance

1. Wireless Charge i Watch magnetically
2. Wireless Charge area for Phone
3. LED Intelligent light
4. Earphone charging connector
5. Non-slip mat
6. Type -C port
7. Non-slip mat
8. product tag
9. Radiator hole

Product Introduction
The3-in-l wireless charger, a compact charging house, powered from only one outlet, can charge3 devices simultaneously. When charge your mobile phone, apple watches, and your AirPods 1 AirPods 2 or AirPods Pro, just put them on, wireless charging will automatically start, all this will make your desk clean and tidy, and make your life easier. The charger is so space-saving designed can help you integrate your mobile phone intelligent and life very well, especially for Apple user. Besides, it is fashion that the light is so shining and has breathing effect showing the charging state

Operation Steps

1. Connect the chager to a 9V/2A,9V/2. 7 A or 12V/2A adapter through a Type-C quick charge cable to switch on the power;
2. Put your phone on then charge;
3.  Put the apple watch on and suck it up to charge,
4. Plug your earphone case in the connector to charge

LED light instructions

• Green light is on
  Standby mode or not charging the phone

• Blue light is breathing:
  wireless charging the phone

• Blue and Green light flash
  Foreign body is detected other phone is misaligned (the phone charging will automatically stop

Charging Schematic Diagram

Applicable Devices

Product Specification

Answer questions

lf you’re experiencing interrupted or slow charging, check the following:

1.  The back of you「phone shou Id not have any meta I, pop sockets, or credit cards
2.  Put the phone in the center of the charging surf ace (this lets the charging coil in you「phone line up with the one inside the wireless charge门．
3. The wireless charging coil on Sony phones is located slightly below center
4. Phone cases should be no thicker than 5 mm for effective charging.
5. (S) Check whether the adapter is QC3.0 fast charger

lf you’re failng to charge your device, please try out the following

1.  Please restart yourcell phone and test with other USB cable
2. Please check whetherthe indicator turns on or not.
3.  Please check the Adapter is QC3.0 Quick Charge『(Output:9V /2A) or not, iPhone original adapter does not match the wireless charger.
4.  Please checkyou「 Phone case thickness(<=Smm). Metal ring or Magnetic Pad w仆I not be available.

lf you’re using the recommended wireless charger with the QC3.0 Adapter and have removed any potential charging obstructions, but are still experiencing issues, try:

1.  Replacing the cable connecting your the wireless charger
2. Rebooting your phone.
3. Unplug the adapter and reinsert

FCC Statement

This device complies with part 15 FCC Rules. Operation is Subject To the following two conditions:

(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not explicitly approved by the party responsible for compliance could void the user’s authority cooperate this equipment.

Note: this equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC radiation exposure
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>