Andreas Stihl Ag Kg SP94 Advance ProCOM Hearing System User Manual

Andreas Stihl Ag Kg SP94 Advance ProCOM Hearing System

ADVANCE ProCOM Manual

Charging

Orange LED : Charging
Green LED: Fully charged

• Pow er On/ Off :Press and hold the (+) Button and Center Button for 1 second Tap the (+) Button and Center Button.
  Volum e Adjustm ent(+) Button – Increase the volume(-) Button – Decrease the volume

• Battery Check When the headset power on Blinking in green = High, 70-100%. You will hear the voice notification, “Battery level is high”.
  Blinking slowly in yellow = Medium, 30-70%. You will hearthe voice notification, “Battery level is medium”.

• Blinking fast in red = Low, 0-30%. You will hear the voice notification, “Battery level is low”.

Music Operation

Play or pause music: Tap the Multi-function Button. Track forward: Tap the Multi-function Button twice.

Mobile Phone Call Making and Answering

Mobile Phone Call Making and Answ ering

Mesh I ntercom
When switching on the headset, the Mesh intercom is automatically activated.

Radio On/ Off

Turn on the FM radio: Press the (+) Button for 2 second. Turn off the FM radio: Press the (+) Button for 2 second.
Radio Seek Stations
Seek up stations: Double tap the Multi-function Button.

Troubleshooting

15.1 Fault Reset when the headset is not working properly, you can easily reset the unit:

1.  Remove the ear cushion of the right earmuff by sliding your fingers under the inner edge of the ear cushion and firmly pulling it straight out.
2.  Remove the sponge.
3.  Locate the pinhole reset button inside the right ear cup.
4. Gently insert a paperclip into the hole and tap the Fault Reset Button with light pressure.
5. The headset will shut down.

Certification and Safety Approvals FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1.  This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.
   This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antennae

3.  Increase the separation between the equipment and the receiver

4. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

5. Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. The antenna used for this transmitter must not transmit simultaneously with any other antenna or transmitter, except in accordance with FCC multi-transmitter product procedures.
When equipped, the distance between antenna and one’s head surface is 31.2mm.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>