3Dsimo BASIC 2 3D Printing Pen Instruction Manual

3Dsimo BASIC 2 3D Printing Pen Instruction Manual

Set contains

• 3DSIMO BASIC 2
  

• service key

• USB charging cable
  

• PCL meterial
  

3DSIMO – BASIC 2
INSTRUCTION MANUAL

Controls and elements

Service cover access

You can easily maintain your 3DSIMO Basic 2

1. Rpen service cover with service key
2. Remove all grinded material and dust, then put cover back onto Basic 2
   

Insertion of material

• Turn-on the Basic
  Device is fully preheated once the LED bar is full.

• Insert material into filament opening.
  Once you feel pressure, go to another step.
  

• Hold extrusion button and check if your material is feeded into the nozzle. After a while, you will see material going out of the nozzle.
  

Ejection of material

• Press retraction button and wait until the LED bar is off. repeat this step three times.
  

• Pull out the material. If you feel tension, press retraction button again.
  

Keep in mind, that ejection of material is possible only when the device is preheated.

Charging

• Plug the Micro USB cable into charging port.
  Check that LED bar shows charging sequention status.
  charging sequention status
  

• Once the charging is done, LED bar show you, that charging process is done.
  charging done
  

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>