ELKO EKO09716 SmartSocket Single 16A Plus Switch Instruction Manual
- June 6, 2024
- ELKO
Table of Contents
ELKO EKO09716 SmartSocket Single 16A Plus Switch
Prerequisites
Download the ELKO Smart app to your smartphone /tablet, and install the ELKO SmartHUB to configure and control ELKO Smart devices.
Product information is available
Detailed product information is available on-line in the system user guide. Scan the QR code or follow the link: http://proff.elko.no/elko-smart
For your safety
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Safe electrical installation must be carried out only by skilled
professionals. Skilled professionals must prove profound knowledge in the
following areas:
- Connecting to installation networks
- Connecting several electrical devices
- Laying electric cables
- Safety standards, local wiring rules and regulations
Failure to follow these instructions will result in death or serious injury.
Getting to know the product
With the SmartSocket Single 16A you can remotely control and monitor the power consumption of the plugged-in load.
NOTE:
The device must not control safety-relevant applications. Do not mix
different load types in the controlled socket. Do not use multi-sockets in the
controlled socket. Do not use for EV charging. The device is equipped with a
temperature protection mechanism. When the device is used with a high load
over a long time, the mechanism can switch the socket off.
Mounting
Setting up
Connecting to the ELKO SmartHUB
For more details, refer to the system user guide.
Pairing to other ELKO Smart devices
To control the product in a room control mode, it can be paired with other
ELKO Smart devices within the same Zigbee network.
For more details, refer to the system user guide.
Resetting to default settings
All configuration data, user data and network data are deleted. All settings
are then set to default settings.
Operating
For more details, refer to the system user guide.
Behaviour of the status LED
For more details, refer to the system user guide.
Technical data
- Nominal voltage: AC 230 V ~, 50 Hz
- Standby: max. 0.4 W
- Fuse protection: 16 A miniature circuit breaker
- Connecting terminals: Screw terminals for max. 2x 2.5mm2, 1.2 Nm
- Operating frequency: 2405-2480 MHz
- Max. radio-frequency power transmitted: < 10 mW
- Protection: IP20
- Measuring accuracy: ± 1% for loads >25 W
- Communication protocol: Zigbee 3.0 certified
Dispose of the device separately from house-hold waste at an official collection point. Pro-fessional recycling protects people and the environment against potential negative effects.
Trademarks
- Zigbee® is a registered trademark of the Zigbee Alliance.
- Apple® and App Store® are brand names or registered trademarks of Apple Inc.
- Google Play™ Store and Android™ are brand names or registered trademarks of Google Inc. Other brands and registered trademarks are the property of the relevant owners.
EU Declaration of conformity
Hereby, ELKO, declares that this product is in compliance with the essential
requirements and other relevant provisions of RADIO EQUIPMENT DIRECTIVE
2014/53/EU. Declaration of conformity can be downloaded on: ELKO.no.
ELKO
ELKO AS
Sandstuveien 68, 0680 Oslo
Pb 6598 Etterstad , 0607 Oslo
+47 67 80 73 00 support@elko.no
www.elko.no
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>