anslut 015591 Ceiling LED Light Instruction Manual
- June 6, 2024
- anslut
Table of Contents
CEILING LED
PLAFOND LED
OPERATING INSTRUCTIONS
An Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions)
SAFETY INSTRUCTIONS
- Read these instructions carefully before installing the product. New installations and extensions to existing systems should always be carried out by an authorized electrician.
- Only intended to be used indoors.
- Designed for installation on the ceiling.
- The light source must only be replaced by a specialist.
- Disconnect the power supply before starting the installation.
- The product must not be covered with anything that obstructs ventilation, e.g. insulation, foil, paper, plastic, or the equivalent.
- Check that the mains voltage corresponds to the rated voltage on the type plate.
- Always follow the electrical specifications on the product labeling.
- Never modify the product, this could result in serious material damage/personal injury, and will invalidate the warranty.
- Check that no parts of the product are missing or damaged. Replace damaged parts before installation.
- Never touch the product when it is in use. Switch off the product and allow it to cool before touching it.
- Do not install the product near sources of heat, or in damp conditions.
- If the cable to this light is damaged it must only the replaced by the manufacturer or service technician, or another qualified person, to eliminate any risks.
ELECTRICAL SAFETY
New installations and extensions to existing systems should always be carried out by an authorized electrician. If you have the necessary experience and knowledge (otherwise contact an electrician), you can replace power switches and wall sockets, fit plugs, extension cords, and light sockets. Incorrect installation can result in fatal injury and the risk of fire.
SYMBOLS
| Read the instructions.
---|---
| intended to be used indoors.
| The product is not dimmable.
****| Approved in accordance with the relevant directives.
| Recycle discarded products in accordance with local regulations.
TECHNICAL DATA
| Rated voltage | 230 V – 50 Hz/12 VDC |
|---|---|
| Output | 12 W |
| Protection rating | IP20 |
| Energy class | F |
| Light source | 1200 I’m |
| Color temperature | 2700 K |
| CRI | ≥80 |
| Life span | 20000 h |
| On/Off | 10000 times |
| Dimmable | No |
| Diffusion angle | 120° |
| Weight | 430 g |
INSTALLATION
IMPORTANT:
Disconnect the power supply before installing the product.
-
Mark where the light is to be mounted.
FIG. 1 -
Drill holes for installation.
-
Insert expander plugs in the drilled holes.
FIG. 2 -
Insert the mains wire through the grommet in the light.
FIG. 3 -
Fasten the light to the ceiling with screws.
FIG. 4 -
Connect the wires to the terminal block on the light.
FIG. 5 -
Screw the glass on the light.
FIG. 6 -
Switch on the power supply.
MAINTENANCE
IMPORTANT:
Disconnect the power supply before cleaning the product. 1. Wipe the light
with a dry or slightly damp cloth. 2. Wait until the light is completely dry
before switching the power supply on again.
NOTE:
Do not use detergents, alcohol, solvents, or the equivalent to clean.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>