HYTRONIK HBTD8200V Bluetooth 1-10V LED Dimmer Instruction Manual

HYTRONIK HBTD8200V Bluetooth 1-10V LED Dimmer

Bluetooth Receiver Node – 1-10V VERSION

Technical Specifications

1. Technical Specifications 10V Receiver Node (Flush mount)
2. Mains voltage 220~240VAC 50Hz
3. Rated load 400VA(Capacitive); 800W(Resistive)
4. Max. load (0/1-10V) 50mA
5. Stand-by power <0.5W
6. Operation frequency 2.4 GHz – 2.483 GHz
7. Transmission power 4 dBm
8. Range (Typical) Protocol 10 ~ 30m
9. Operation temperature 5.0 SIG Mesh
10. Case temperature (Max.) Ta: -20°C ~ +45°C
11. Storage temperature Tc: +75°C
12. Max. relative humidity -20°C ~ +60°C
13. IP rating 20 ~ 90%
14. Impulse withstand voltage IP20
15. Duty type 2.5KV
16. Insulation material S1
17. Glow wire PTI material group IIIa
18. Protection level 3, 850°C
19. Type of switch Built-in protection provide
20. Insulation Single load(single-ploe disconnection)
21. EMC standard (EMC) Class II Pollution degree 2
22. Safety standard (LVD) EN55015, EN61547, EN61000-3-2, EN61000-3-3
23. Radio Equipment (RED) IEC 61058-1, EN 61058-1, IEC 61058-1-2 EN 61058-1-2, AS/NZS 61058.1 EN300 328, EN301489-1, EN301489-17, EN62479

Download the App

Free App for set-up and commissioning

Dimming Interface Operation Notes

Switch-Dim

The provided Switch-Dim interface allows for a simple dimming method using commercially available non-latching (momentary) wall switches. Detailed Push switch configurations can be set on the Koolmesh app.

Push switch

| Short press (<1 second)

• Short press has to be longer than 0.1s, or it will be invalid.

| – Turn on/off – Recall a scene

– Turn on only – Exit manual mode

– Turn off only – Do nothing

Double push

| – Turn on only – Exit manual mode

– Turn off only – Do nothing

– Recall a scene

Long press (≥1 second)

| – Dimming

– Colour tuning

– Do nothing

Simulate sensor| /| – Upgrade a normal on/off motion sensor to a Bluetooth controlled motion sensor

Installation

Warnings:

1. Installation must be carried out by a qualified engineer in accordance with local regulations.
2. Disconnect power supply before installing.
3. Ensure environmental conditions are suitable for electronic equipment.

Wire Preparation

Wiring Diagram

Additional Information / Documents

1. To learn more about detailed product features/functions, please refer to www.hytronik.com/download ->knowledge ->Introduction of App Scenes and Product Functions
2. Regarding precautions for Bluetooth product installation and operation, please kindly refer to www.hytronik.com/download ->knowledge ->Bluetooth Products – Precautions for Product Installation and Operation
3. The datasheet is subject to change without notice. Please always refer to the most recent release on www.hytronik.com/products/bluetooth technology ->Bluetooth Sensor ->Receiver Nodes
4. Regarding Hytronik standard guarantee policy, please refer to www.hytronik.com/download ->knowledge ->Hytronik Standard Guarantee Policy

References

• iot.koolmesh.com
• iot.koolmesh.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>