Anderic UC7058GM Ceiling Fan Remote Receiver Instruction Manual
- June 12, 2024
- Anderic
Table of Contents
Anderic® UC7058GM Installation Instructions.
Notes:
This receiver may not work with your existing remote. If you need a compatible
remote for this receiver, please purchase the Anderic® RR7080T.
Installation instructions:
- Turn the power off to the fan from the circuit breaker box.
- Remove the screws from the receiver cover (located on top of the motor housing).
- Remove any zip ties holding down the wires.
- Loosen the screw holding down the clip which holds the power wires and antenna wire (if necessary).
- Use plyers to remove the crimps holding the receivers blue and white wires.
- Disconnect the 9-pin connector.
- Remove the two screws holding down the receiver.
- Install the new receiver using the same steps above in reverse order. Using wire nuts to connect the blue and white wires from the receiver to the blue and white wires from the fan.
Pairing with remote:
Note: This unit has a total of 16 different code combinations using the four dip-switches located in the remote and on the receiver.
- On the remote: Remove battery cover and set the dip-switches to any pattern.
- On the receiver: Set the dip-switches to the same pattern as the remote.
See diagram below.
For additional support please go to Anderic.com or call
1-855-263-3742.
Anderic is a registered trademark of Dan’s Electronics Etc., Inc.
Copyright 2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>