HAMRON 016011 Extra LED Light Instruction Manual
- June 6, 2024
- HAMRON
Table of Contents
HAMRON 016011 Extra LED Light
SAFETY INSTRUCTIONS
- Read these instructions carefully before installation and save them for future reference.
-
Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.
SYMBOLS|
Read the instructions.
| Approved in accordance with the relevant directives.
| Recycle discarded product in accordance with local regulations.
TECHNICAL DATA
DESCRIPTION
- The packaging contains the following: 1. Extra LED light with fastener
- Installation kit
- DT connector (see cable color coding)
FIG. 1
ETM
Thanks to Electronic Thermal Management (ETM) the intensity of the diodes is maintained and discoloring is avoided if the heat becomes excessive.
TIR REFLECTOR
A traditional reflector directs and focuses most of the light, but is far from all of it. The reflectors for this lamp have Total Inner Reflection (TIR), which means that all the light is reflected and directed before it is sent out from the reflector. This minimizes light wastage.
INSTALLATION
- Disconnect the negative/chassis earth cable from the battery before connecting the product, to avoid damage from short-circuiting during the installation.
- Follow as far as possible the existing cable routing for the installation of new cables. Carefully fasten the cable and any excess length with cable ties, insulating tape or the equivalent. Cable grommets through the firewall should be at a safe distance from moving parts.
- Drill screw holes with a diameter of
- 5 mm in the surface where the product is to be installed.
- Put the screws in the holes, put on the lock washers and tighten the nuts.
NOTE: The E-marking is not valid unless the yellow-orange light is used a parking light.
Cable color coding
Explanation of DT connector’s colored cables
Black
Headlight, parking light, and position light (yellow-orange)
Red
Headlight
White
Parking light (white)
Yellow
Position light (yellow-orange)
WARNING!
- The product must only be used within its rated voltage range, 12 to 24 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.
References
- Jula – products for home and garden
- Jula - ingenting kan stoppe deg nå!
- Jula - Teraz nic Cię nie powstrzyma!
- Jula – inget kan stoppa dig nu!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>