ENVIROLITE HB2B19DMP50 LED High Bay Instruction Manual
- October 27, 2023
- EnviroLite
Table of Contents
LED HIGH BAY, 5000K,
120-277V, 0-10V DIMMING
Model: HB2B19DMP50
Instruction Manual
HB2B19DMP50 LED High Bay
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions. Failure to do so may lead
to electrical shock or fire, which may cause injury or death.
For questions, problems, or missing parts call the Customer Service line at
(855) 573-6156 from 8 AM to 6 PM EST Monday – Friday.
CAUTION
WARNING – RISK OF FIRE: Turn off the main power at the circuit breaker before
installing the fixture or performing other maintenance in order to prevent
possible shock.
GENERAL
All electrical connections must be in accordance with local, and national
electrical codes.
Prior to installation remove all protective plastic film covering from the
fixture.
Tools needed for installation: Phillips screwdriver, wire strippers, and
pliers.
DIMMING
- Use a 0-10V dimmer only.
- If the fixture will be connected to a dimmer, punch out one of the knockouts (A) located at each end of the fixture and pull the dimming wires out through that knockout (A). [Fig. 1]
- Remove the front plate (B) along the center of the fixture by removing the screw (C) at the end of the front plate (B).
- Bring in the wires from your dimmer and make the connections inside the fixture channel. Insert the purple dimming wire into the quick connecter with the purple fixture wire. Insert the grey or pink dimming wire into the quick connector with the grey fixture wire.
- Secure the front plate (B) back onto the fixture using screw (C). [Fig. 2]
120V INSTALLATION
- Put a chain through the hangers. Hook the hangers into the round holes on the ends of the fixture. [Fig. 3]
- Insert the plug into an outlet.
277V INSTALLATION
-
Remove the access plate (D) by removing the screw (E) and securing it in place. [Fig. 4]
-
Punch out one of the knockouts (F) on the access plate (D). [Fig. 4]
-
Insert the supply wires into the quick connector (D) aligning the black supply wire with the black fixture wire and the white supply wire with the white fixture wire. [Fig. 5] Connect the supply ground grey/yellow wire to the fixture ground wire using a wire nut.
-
Secure the access plate (D) back onto the fixture using the screw (E) that was previously removed. [Fig. 4]
-
Hook the hangers into the round holes on the ends of the fixture. [Fig. 3]