itel S23 Sky Blue 128GB 8GB Smartphone User Manual
- June 15, 2024
- itel
Table of Contents
itel S23 Sky Blue 128GB 8GB Smartphone
Product Information
Specifications:
- Model: S23
- Operating System: AndroidTM (Android is a trademark of Google LLC)
- Display: 6.56″ FHD CTP+LCM
- Front Camera: 8MP
- Back Camera: 50MP
- Waterproof: Yes
- Sim Card Slots: 2
- SD Card Slot: Yes
Know your phone:
SIM/SD card installation:
- Power off your mobile.
- Refer to the following picture for SIM/SD card installation:
Charging the phone
You can charge your device using a charger or by connecting it to the computer
using a USB cable (comes with the phone).
Note: Use only itel charger and cables. Other chargers or cables may
damage the device and invalidate your phone warranty.
FAQ
FCC Caution
Q: What are the labelling requirements for this device?
A: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Q: Can I make changes or modifications to the equipment?
A: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for Specific Absorption Rate (SAR).
Explosion diagram specification
1 | (CTP+LCM)6.56FHD | 2 | FRONT HOUSING ASM |
---|---|---|---|
3 | UP SPK | 4 | F CAM RUBBER |
5 | F CAM 8M | 6 | BACK CAM CON FOAMS |
7 | BACK CAM 50M | 8 | MAIN PCBA |
9 | RCE D | 10 | BACK CAM CON FB |
11 | F CAM COOPER | 12 | TP BTB RUBBER |
13 | BAT RUBBER | 14 | BACK CAM B |
15 | RCAM RUBBER 8W | 16 | UP FRAME ASM |
17 | M PCBA WATERPROOF MYLAR | 18 | MID FRAME GRAPHITE |
19 | CARD HOLDER | 20 | LOWHOUSING ASM |
21 | FINGER FPC MYLAR | 22 | BATTERY COVER |
23 | CAM DECO ASM | 24 | FLASH LENS ASM |
25 | CAM LENS BACK HSV | 26 | SCERW M14 D25 |
27 | SIDEKEY ASM | 28 | BL 49F |
29 | RF CABLE | 30 | USB RUBBER |
31 | EARJACK RUBBER | 32 | SUB LCM FPC CONN RUBBER |
33 | SUB PCBA | 34 | DOWN SPK |
35 | Motor |
Know your phone
- Front camera
- Volume + key
- Volume – key
- Power key & side fingerprint sensor
SIM/SD card installation
- Power off mobile.
- Refer to the following picture for SIM / SD card installation.
Charging the phone
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). Use only itel charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
FCC Caution
Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Information to user.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. FCC
RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. Device types: S665L (FCC ID: 2AJMN-S665L)
has also been tested against this SAR limit. The highest SAR value reported
under this standard during product certification for use at the ear is 1.23
W/kg and when properly worn on the body is 0.55 W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
Operating System:AndroidTM
Android is a trademark of Google LLC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>