OMOTON BM002 Wireless Mouse User Manual

June 5, 2024
OMOTON

Wireless Mouse

User Manual

Specification

Connection mode: Bluetooth Connected by: BT 5.0 Mouse Lifelong Clicks: 3 filial Numbers it Buttons: 3 Dpi levels: 30011200/1800 DPI Operating Range: 10m/33ft Power Support: 1 XAAbattery Working Current: <10mA Net weight: 50g Dimensions: 103 x 80 x 28mm Warranty Information: 18 months

Package Contents

lx User Manual
lx Wireless Mouse

Product Overview

  1. Bluetooth Status Indicator
  2. Vertical Scrolling
  3. ON/OFF Slider
  4. Bluetooth Connection Button

Cursor Speed Control(CPI)

By pressing the vertical scrolling and right button for more than 3 seconds at the Clemente, you can toggle the DPI of 800DP1,1200DPI. 1600DP1.

Operation Methods

Preparation for connecting to the Pad

  1. Make sure the system of the iPad has been updated to iPsdOS 13 and above.
  2. Go to Setting-Select Accessibility-Turn on the ‘Assistive Touch’.
  3. Tum on the Bluetooth setting on the system.

Preparation for mous

  1. The ONtOFF slider should be in the ON position Bluetooth Status Indicator will nosh 2-3 times end be light off.
  2. Long press the Bluetooth connection button for more than 5 seconds until the Indicator light lashes quIckly.then you can start pairing.
  3. Tum on the Bluetooth function of the device, connect to the BT3.0 Micutesor 5.0 MMAO, and complete the connection.

Power management

Power Saving Mode
The mouse will automatically go to sleep after 10 minutes of inactivity. Press any button and wait 3 seconds to activate It.
Replace batteries
Lift the battery compartment up and off the base. Replace the spent batteries with new 1•AA battery and reattach the compartment door (Bette ry re not Included)
Note: Make sure that the positive Oland negative (-) terminals are on the correct sides.

Troubleshooting

If you cannot connect a Bluetooth mouse to the device, or If the mouse Is not working, please try the following:

  1. Make sure your device has Bluetooth and Bluetooth enabled.
  2. Restart the device and try to pair again.
  3. Install a new battery and try pairing again.
  4. Cancel the Bluetooth connection with other devices and try to pair again.
  5. Check if the Bluetooth software has been updated recently. and try to pair again after updating.
  6. Malte sure the Bluetooth mouse is within 10 meters of your device.

IMPORTANT SAFEGUARDS & PRECAUTIONS

  1. SAVE THESE INSTRUCTIONS- This sheet contains Important safety end operating instructions.
  2. Remove the batteries If the product Is not going b be used for a long period of time.
  3. For indoor use only. Never expose to direct sunlight or wet weather conditions.
  4. Do not use if the equipment is damaged.
  5. Do not disassemble the product. DI may result in Ina risk of safety hazards.
  6. Do not throw or shake the product.

FCC Caution:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

B M002
Manufactured by/Fabriqui pa/
Fabricado po /Merges-len von/
Fabbricato da: Shenzhenshi Huiteng
Technology Co.l.td, Roorn428 F/4,
Shifeng Building, 6267 Baoan Road,
CbiDiOU Community, Fuyong Street,
Baoan District, Shenzhen,
Guangdong China 518103

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals