OMOTON VM01 Vacuum Magnetic Car Phone Holder User Manual

OMOTON VM01 Vacuum Magnetic Car Phone Holder User Manual

Product Specifications

Product includes

• Magnetic Sucker
• Air Vent Hook
• Cleaning Kit
• PE Protective Film
• Metal Ring
• Location Card

Product Specifications

1. Magnetic Sucker
2. Vacuum Suction Cup
3. Release Button
4. Bolt
5. Nut
6. Joint Ball
7. Hook-Adjust Knob
8. Support Ring

Installation Guide

1. Loosen the nut.
   

2. Insert the joint ball into the nut.
   

3. Tighten the nut after inserting the joint ball into the bolt completely.

4. Turn the hook-adjust knob counterclockwise to adjust the hook to the longest length.

5. You can rotate the support ring to fit your air vent if the support ring is obstructed.
   

6. You can remove the support ring if the size of your air vent is too small to install the support ring.
   

7. Hang the hook on the air vent blade and tighten the hook-adjust knob clockwise until the hook is locked. (The air vent blade should be kept horizontal for a better locking effect).
   

8. Loosen the hook-adjust knob to remove the mount from the air vent blade.
   

This product is suitable for iPhone 12, 13, 14 series and later models, compatible with original and third-party MagSafe phone cases. Other phones or phone cases must install the metal ring on the back to use.

Installation Steps of the Metal Ring

1. Open the cleaning kit. Wipe the back of the phone or phone case with the wet alcohol cloth firstly, then dry with a dry cloth.
   

2. To better protect your phone or phone case, itis recommended to use the PE film. Tear off the PE film and stick it in the center of the back of the phone or phone case.
   

3. Place the location card on the phone’s back with the values on the symmetrical side equal to ensure the circle in the center.
   

4. Remove the metal ring’s protective film, center it on the location card, and press it lightly. Remove the location card after confirming that the metal ring isin the exact center of the card, and then press the metal ring for 5 seconds. After that, wait six hours before using.
   

5. Put your phone close to the magnetic sucker, then it will automatically attach to the mount. At this point, the magnet and the vacuum suction cup will start working simultaneously to secure your phone to the mount.
   

6. Press and hold one of the release buttons and tilt the phone at the same time to take the phone off. Do not take the phone off directly as this could harm the air vent blade or the phone.

Precautions

1. Please stick the metal ring on the back of your phone or phone case to ensure the magnet works well.
2. Please use this product on a smooth and flat phone case. Do not stick the metal ring to the phone case with a rough back (such as rough texture, rubber paint, cloth, etc.), as this will affect the sticking effect of the metal ring and the adsorption force of the suction cup.
3. Use the location card to find the position of the metal ring before attaching it to prevent interference with wireless charging.
4. Low temperature will affect the paste effect. Itis recommended to wait 12 hours after installing the metal ring before using this product.
5. Please push the release button simultaneously when taking off your phone. Do not take your phone off directly as the vacuum suction cup’s strong adsorption force could harm it.
6. Please don’t hesitate to contact us if you have any questionsthis or product isn’t right for your car’s air vent. We will do our best to assist you.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>