FALCON RIDGE Honda Talon 1000 Doors and Rear Window Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE Honda Talon 1000 Doors and Rear Window
Instruction
CAUTION: Do not smoke inside the cab or expose the enclosure to direct
flames. Product is FLAMMABLE.
Be sure to read these instructions thoroughly before opening and installing
the enclosure. The installation is best done when the temperature is 70°F or
warmer. If installed outside and in the cold weather, warming the adhesive
Velcro strips just before installation is recommended.
-
Carefully open the carton and roll out the enclosure on a large flat surface that is clean and free of dirt or other material that may soil the textile or scratch the clear vinyl windows of the enclosure.
-
Check over the parts included in the carton with the parts list shown below:
- Velcro hook strips 32 each 3” long
- Velcro hook strips 2 each 6” long
- Velcro hook strips 2 each 12” long
- Velcro hook strips 2 each 20” long
- Velcro hook strips 2 each 40” long
- Cab enclosure 3 Pieces
-
Begin by opening up the enclosure and with the help of another person drape the enclosure over the roll cage and arrange into the correct position.
-
You will notice double-sided Velcro strips sewn to the cab enclosure. At these locations, wrap the roll bar with one of the 3” adhesive Velcro strips. After wrapping the Velcro around the bar wrap the double-sided strip around the adhesive Velcro providing a very secure hold.DO NOT DO THIS DOWN THE BACK OF THE DOOR. Pictures on next page show how this works.
-
When you get to the back of the door, take the 20” adhesive strips and place them down the roll cage so it faces the rear of the vehicle. Then wrap the double-sided strips around the bar as shown in the picture below.
-
After attaching the double-sided strips go to the bottom of the door. Pull the bottom of the door up and place the 40” adhesive strip on the Velcro sewn to the door. Leave the paper backing on it as you put it on then peel it off after getting it in place. See Photos below.
-
Then pull the bottom of the door down and attach it to the Talon door. Make sure to rub it down good before peeling the door back off the Velcro.
-
Remove the bottom of the door and take a knife and cut the Velcro where the back of the door hinges at. See photo below
-
Next place the 6” adhesive strips on the vehicle to match up with the front portion of the door as shown in the photo below.
-
Lastly place the other 6” adhesive strips on the vehicle to match up with the Velcro on the very front bottom part of the door as shown below.
-
Along the top of the Rear Window you will see 6 double-sided Velcro strips. At each of these, place a 3” adhesive hook strip in the inside of the roll cage. This holds the double-sided strip in place. See images below
-
Next attach the sides to the Velcro you placed on the roll cage for the rear of the doors.
-
Lastly place the two 12” adhesive hook strips behind the seats as shown in the picture below.
-
Then attach the bottom of the rear window and that concludes your installation.
Cleaning and Storage Recommendations
- Before removing the Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Thank you for your purchase!
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from date item is received. You MUST package the product exactly as it
was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes. Lay all the windows on top of each other with the canvas
folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory new condition to receive refund – a
25% restocking fee will apply.
If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors, you must first call them and see
what their return policy is. Once your item reaches our production facility,
our customer satisfaction team will inspect your item to ensure unused,
factory new condition. NOTE: All windshields must be returned with the
original protective film intact and not removed. Do NOT REMOVE if you have any
intentions of returning the item. Refund/ replacement of a windshield will
only be processed on items with original protective film or if the windshield
is defective.
Items must be properly packaged in the original shipping carton to protect
them during transit and ensure your returned item arrives back factory fresh,
and in new resalable condition (any returned items that have been used,
altered or damaged in any way will not be subject for a refund.) All contents
including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will
be approved. Once returned items are received, credit will be issued to the
original credit card/ payment method used for the purchase. Outbound shipping
and return shipping cost will not be refunded. Please allow 4 to 6 weeks for
your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure,
tops and/or windshield due to defect of the product. Please refer to the
return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this
time frame we will gladly correct the problem or replace the enclosure, tops
&/or windshield. Upon submitting for the correction or replacement we will
need to receive pictures of the defect in material or workmanship along with
the receipt from the date of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>