airplex SGP104B Scania NTG 2024+ StoneGuard Installation Guide
- June 5, 2024
- airplex
Table of Contents
airplex SGP104B Scania NTG 2024+ StoneGuard
INSTALLATION INSTRUCTIONS
PLEASE READ THE INSTRUCTIONS COMPLETELY BEFORE INSTALLATION
Installation of ‘A’ Pillar Brackets
-
Open the bonnet/grill of the truck. Open each side faring to access the bolt that holds each ‘A’ pillar cowling
-
Remove each cowling bolt. (Fig.1)
Pry off the plastic pillar cowling (held on by the 5 pins shown in Fig. 2) and remove pillar cowlings from the truck cab
-
See cowling image Fig.2. Identify the two pins and corresponding holes in the cab ‘A’ pillar
-
Drill the existing 2 holes in the ‘A’ pillar out to 9mm, using 9mm drill bit.
-
Apply rust preventative to the freshly drilled holes
-
Install and firmly set the supplied M6 Nutserts to the two holes on each side of the cab.
-
Remove and discard the two locating pins from the plastic cowling (Fig.2)
-
Drill through the plastic cowling with the pilot drill in the original pin positions
-
Drill the cowling out to the final 13mm hole size. De-bur any rough edges on the plastic
-
Refit the plastic cowlings to the truck cab ‘A’ pillars
-
Attach the stone guard to the ‘A’ pillars.(Fig. 3)
Assembly sequence:
- Spacer in the hole of the cowling
- Stoneguard
- M6 spring washer
- M6 x 30mm machine screw
Fasten securely !!
Installation of Front Support Bracket
Identify the ‘star’ bolt below the center of the windscreen shown in Fig.4.
Loosen 10mm but do not remove this bolt. This will allow better access to
install the support bracket.
- Offer the support bracket (Fig. 5) down in behind the plastic cowling above the bolt loosened in 11.
- Locate the M6 hole in the truck just behind the plastic.
- Fasten the support bracket with supplied M6 x 30mm stainless machine screw, washers and nylon nut.
- Fasten the support bracket to the stone guard
- Re-fasten the front ‘star’ bolt.
- Carefully open the bonnet and take note of the bonnet handles as they approach the stone guard. The handles should sit evenly between the recess cutouts in the stone guard rail.
- Adjust the stone guard by pulling to the left or right to ensure it sits evenly around the handles.
Specifications
- Manufacturer: AIRPLEX INDUSTRIES LIMITED
- Product: SCANIA NTG 2024+ StoneGuard (SGP104B)
- Material: Stainless Steel
- Installation Location: Truck cab exterior
FAQ
Q: How do I adjust the stone guard to fit around the bonnet handles?
A: To adjust the stone guard, pull it to the left or right to ensure it sits
evenly around the handles.
Q: What size drill bit should be used for drilling holes in the `A’
pillar?
A: Use a 9mm drill bit to drill out the existing holes in the `A’ pillar.
Q: What material is the StoneGuard made of?
A: The StoneGuard is made of stainless steel.
AIRPLEX INDUSTRIES LIMITED
AUTOMOTIVE ACCESSORY MANUFACTURERS 21 SALEYARDS ROAD, OTAHUHU, AUCKLAND, NEW
ZEALAND P.O. BOX 11-286, ELLERSLIE, AUCKLAND, NEW ZEALAND PHONE 64 (9)
276-9826 – FAX 64 (9) 276-9836 Email
info@airplex.com,
www.airplex.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>