KICHLER 45295CH Alton 5-in 1-Light Chrome Industrial Vanity Light User Manual
- June 3, 2024
- KICHLER
Table of Contents
We’re here to help866-558-5706
Hrs: M-F 9 am to 5 pm EST
45295CH Alton 5-in 1-Light Chrome Industrial Vanity Light
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fuse box before
starting and during the installation.
-
Attach the mounting strap to the outlet box using the (2) two supplied mounting strap screws. The mounting strap can be adjusted to suit the position of the fixture.
-
Grounding instructions: (See Illus. A or B).
A) On fixtures where the mounting strap is provided with a hole and two raised dimples. Wrap ground wire from outlet box around the green ground screw, and thread it into the hole.
B) On fixtures where a cupped washer is provided. Attach ground wire from the outlet box under the cupped washer and green ground screw, and thread it into the mounting strap.
If the fixture is provided with ground wire. Connect fixture ground wire to outlet box ground wire with a wire connector.
After following the above steps. Never connect a ground wire to black or white power supply wires.
-
Make wire connections. Reference the chart below for correct connections and wire accordingly.
Connect Black or Red Supply Wire to:| Connect White Supply Wire to:
---|---
Black| White
‘Parallel cord (round & smooth)| *Parallel cord (square & ridged)
Clear, Brown, Gold, or Black without tracer| Clear, Brown, Gold or Black with tracer
Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
*Note: When parallel wires (SPT I & SPT II) are used. The neutral wire is
square shaped or ridged and the other wire will be round in shape or smooth
(see illus.)
-
Push fixture to wall, carefully screws in the (4) fixture mounting screws through holes in the sides of the canopy.
NOTE, the fixture can be mounted with the glass in the up or down position. -
Insert recommended bulb (not included).
-
Set glass down over socket.
-
Thread the three (3) thumbscrews into the base as shown.
(DO NOT over-tighten.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>