sauermann TM 110 Temperature Transmitter User Guide
- June 5, 2024
- sauermann
Table of Contents
sauermann TM 110 Temperature Transmitter
Dimensions
Stainless steel probe technical specifications (duct model): Ø6 mm contact tip; available lengths: 100 mm, 150 mm, 200 mm, 250 mm or 300 mm.
Symbols used
For your safety and in order to avoid any damage of the device, please follow the procedure described in this document and read carefully the notes preceded by the following symbol:
The following symbol will also be used in this document, please read carefully the information notes indicated after this symbol:
Connections
- Terminal block (only for model with terminal block)
- Switch
- LCC-S software connection
- Output terminal block
- Power supply terminal block
- Cable gland
Connection of a Pt100 probe on the terminal block
Electrical connections as per NFC15-100 standard
This connection must be made by a qualified and trained technician. To make the connection, the transmitter MUST NOT BE ENERGIZED.
- For TM110 – AO and TM110 AN models with – 0-10 V output – active, 4 wires:
- To make a 3-wire connection, BEFORE POWERING UP THE TRANSMITTER please connect the output ground to the input ground. See drawing below.
- For TM110 – PO and TM110 – PN models with 4-20 mA output – passive:
Settings and use of the transmitter
Configuration
CAUTION: the transmitter MUST NOT BE ENERGIZED before a configuration. Then,
proceed to the required settings, with the DIP switches (as shown on the
drawings hereafter). Once the transmitter configured, it can be powered up.To
configure the transmitter, unscrew the 4 screws of the casing then open it.
The switches allow the different settings are accessible.
Measuring range setting
To set a measuring range, put the switches 1, 2 and 3 of the measuring ranges
as shown in the following table.
Unit of measurement setting
To set the unit of measurement, put the on-off switch 4 as shown in the
following table.
Configuration via LCC-S software (option)
An easy and friendly configuration with the software! It is possible to
configure intermediate ranges. 
The minimum difference between the high
range and the low range is 20. Example: for a 0-100 °C transmitter, the
minimum delta of the range is 20 °C. It is then possible to configure the
transmitter from 0 to +100 °C, or from 0 to +20 °C, etc. To access the
configuration via software: Set the DIP switches as shown beside. Connect the
cable of the LCC-S to the connection of the transmitter. The configuration of
the parameters can be done either with the DIP switch or via software (you can
not combine both solutions).
Mounting
To install the transmitter, mount the ABS plate on the wall (drilling: Ø6 mm, screws and pins are supplied). Insert the transmitter on the fixing plate (see A on the drawing beside). Rotate the housing in clockwise direction until you hear a “click” which confirms that the transmitter is correctly installed. The mounting plate is not available for ambient models. 4 fixing holes inside the back housing can be used to install the transmitter on the required location.
Maintenance: please avoid any aggressive solvent. Please protect the transmitter and its probes from any cleaning product containing formalin, that may be used for cleaning rooms or ducts.
Precautions for use: please always use the device in accordance with its intended use and within parameters described in the technical features in order not to compromise the protection ensured by the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>