AUDEZE 206-TR-1121-00 Filter Wireless Conference Speakerphone User Guide

AUDEZE 206-TR-1121-00 Filter Wireless Conference Speakerphone

Overview

FUNCTION

SPECIFICATION

• Microphone .. Dual microphone
• Microphone range. 10 ft.
• Beam-forming range  360, 105, 90, 70°
• Noise reduction    Intelligent zero-noise
• Speaker transducer. Planar Magnetic
• Magnetic structure  Fluxor” magnet array
• Magnet type. Neodymium N50
• Diaphragm type …… Ultra-thin Uniforce
• Transducer size. . ….. 70 x 105 mm
• Maximum SPL . Normal 85dB@ 3ft; Ludicrous 118dB@ 2ft, 75dB @ 45ft
• Frequency response. 300Hz 20kHz
• Speaker THD. <0.2% (1kHz, ImW)
• Battery type 1050mAH Lithium-polymer
• Wired Connection.. USB-C, USB-A
• Wireless Connection. Bluetooth 5.0: A2DP, AVRCP, HFP, BLE; SBC, AAC, and aptx Classic codecs
• Construction.  Die-cast aluminum
• Weight.. 280g
• Dimension 76 x 152 x 11mm
• Network Standards KF 5.2
• Frequency range SiFe…
• Occupied Bandwidth 5B5.. MHz
• Transmit power 2402 to 2480MHz
• Max (W)  5W
• Max (Hz)   .. 32MHz
• Operation Voltage range (V ) .. DC 5V
• Operation Current range (A )… 1A

Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, it is not installed and used in accordance With the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement: This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons.
Radiation Exposure Statement: The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such a function is available. Industry Canada Statement: This device complies with ISED’s license-exempt RSSs.
Operation is subject to the following two conditions: This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Radiation Exposure Statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body.

• This telecommunication equipment conforms to the technical standards or requirements of NBTC.
• This device complies with Directive 2014/53/EU issued by the Commission of the European Community.
• Hereby, Audeze declares that the radio equipment type Bluetooth is in compliance with Directive 2014/53/EU.
• The full text of the EU declaration of conformity is available on the Audeze website: www.audeze.com
• The insulating layer is applied to the surface of metal objects, coating declared as insulating by the manufacturer shall only be submitted to the air discharge. The contact discharge test shall not be applied to such surfaces

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>