KLARSTEIN 10035578 Ice Cube Maker Instruction Manual

10035578 Ice Cube Maker
Instruction Manual

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damage. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

https://use.berlin/10035578

TECHNICAL DATA

SAFETY INSTRUCTIONS

In order to avoid any accidents, please refer to the following operation:

• Disconnect power before servicing.

• Do not pull directly on the wire when plugging or unplugging the unit.

• If ice is abnormal, please call the seller.

• It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be hot. Please don’t touch it.

• Due to fast freezing, ice cubes may appear “Cloudy”. This is trapped air in the water and it will not affect the quality or taste of ice.

• When out of use, please open the drawer at least 2cm to allow for air circulation and avoid any metallic components becoming rusted.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.

• Children shall not play with the appliance,

• Cleaning and user maintenance shall not be made by children without supervision.

• If the supply cord is damaged; it must be replaced by the manufacturer, its service agent, or a similarly qualified person in order to avoid a hazard.

• Please according to local regulations regarding disposal of the appliance for its flammable blowing gas. Before you scrap the appliance, please take off the doors to prevent children trapped.

• This appliance is intended to be used in household and similar applications such as
  – staff kitchen areas in shops, offices, and other working environments;
  – farmhouses and by clients in hotels, motels, and other residential type environments;
  – bed and breakfast type environments;
  – catering and similar non-retail applications.

• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

• Children aged from 3 to 8 years are allowed to load and unload refrigerating appliances.

• Opening the door for long periods can cause a significant increase in the temperature in the compartments of the appliance.

• Clean regular surfaces that can come in contact with food and accessible drainage systems.

• Clean water tanks if they have not been used for 48 h.

• If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mold from developing within the appliance.

• When positioning the appliance, ensure the supply cord is not trapped or damaged.

• Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.

• Fill with potable water only or connect to potable water supply only.

• Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

• Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

• Do not damage the refrigerant circuit.

• Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

• Risk of fire / flammable materials, taking care to avoid causing a fire by igniting flammable material.

• The new hose sets supplied with the appliance are to be used and the old hose sets should not be reused.

PRODUCT DESCRIPTION

Before/First Use of Your Ice Maker

1. During transportation, the incline angle of the cabinet should not be over 45 °C.
   Do not turn the Ice maker upside down. As this may damage the compressor and sealed system.

2. Remove all packing material and carefully check your ice maker to ensure it is in good condition and that there is no damage to the ice maker or power cord and plug.

3. The Ice maker should be placed horizontally on a level surface. To ensure proper ventilation for your Ice maker allow 150mm of space at the top, the back, and on each side. Do not install the Ice maker near an oven, radiator, or any other heat source.

4. Before using the Icemaker for the first time, please wait 2 hours after positioning it, and keep the front lid open for at least 2hours

5. Ensure that the voltage indicated on the ice maker corresponds with the voltage in your home.

6. Pure water is not allowed to be used on this unit, spring water is recommended.

7. Please always keep the viewing window close during ice making.

CONTROL PANEL OPERATION

| Press this button to shave ice.
Before the press of this button, please put enough ice into the bowl and covers the bowl cover well.
| The unit under ice-making process if it lights up without flash
| It lights up when the ice in the ice basket is full.
| It lights up when the water in the water tank is not enough.
| Press it to start the ice-making.

OPERATING INSTRUCTIONS

Step 1
Add water by manual: Open the lid, take it out of the ice basket and fill the water reservoir with water.
Note: Make sure the water is not over the bottom of the ice collecting tray.
Add water by auto fi lling: please connect the pipe at the back of the unit to the water tap directly.

Note The maximum permissible inlet water pressure: is 0.6 MPa. The minimum permissible inlet water pressure: is 0.14M Pa.
Step 2
Connect to the power
Step 3
Press the ICE button to turn the unit on. The ice maker begins to work.
Note: For the first three cycles, the ice may be small and irregular in size, or even no ice.
Step 4
If the indicator ADD WATER lights up, please take out the basket, then add water as per step 1.
Step 5
If indicator ICE FULL lights up, please take out the ice with the scoop.
Note: When the ice basket is full please remove the ice immediately, Do not allow the ice collecting tray to overfill.
Step 6
Press SHAVED ICE button to shave ice.
Note: Before the press of this button, please put enough ice into the shaved ice bowl and cover the bowl cap well.
Step 7
Press the ICE button to stop the machine.
Step 8
Put a tank below the unit, then pull the unit a little forward, and pull the drain plug in the middle of the tank to drain water.

CLEANING AND CARE

• Clean the inner liner, ice collecting tray, water box, ice shovel, and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Icemaker. Do not spray the Ice maker with chemicals or diluted agents such as acids, gasoline, or oil. Rinse thoroughly before starting.
• Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• To ensure the cleanliness of the ice cubes, water in the water reservoir is suggested to be replaced every 24 hours.
• If the compressor stops for any reason such as water shortage, too much Ice, power off, etc. Do not start the system right away, wait 3 minutes, and then re-start the Icemaker.
• Always use fresh water before starting ice production either at initial installation or after a long shut-off period.
• This unit is for home use only, not for outdoor use, if it is necessary for use outside, please make sure the view window is closed.

TROUBLESHOOTING

1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power button has been pushed off during an ice-making cycle, small ice chips may form and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please restart the ice maker by pressing Stop and then Start. If the Ice shovel does not push the Ice into the Ice collector after the formed Ice drops from the evaporator finger while at the same time the M light is on, check to see if the water tray is horizontal or balanced. If not then adjust by pressing the Ice shovel lightly with your finger. Then re-start the Icemaker.

is normal.
Conditions for Ice making Cycle are right but no ice is made.| Refrigerant leaks. The sealed system is blocked.| Call for service.
The lights of ice are full and add water comes at in the same time.| The water tray is blocked by an ice cube.| Clear the ice cube under the ice shovel pull out the plug and insert It
again then press the ICE button, 3 minutes later the machine will restart automatically.
The machine keeps running, but the water is warmer than the normal water.| The magnetic valve is broken.| Replace the magnetic valve.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

MANUFACTURER & IMPORTER (UK)

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>