AENO SC3 Cordless Vacuum Cleaner User Guide
- June 5, 2024
- AENO
Table of Contents
AENO SC3 Cordless Vacuum Cleaner User Guide
AENO SC3 Vertical Vacuum Cleaner is a household appliance designed to clean dust and small rubbish from all types of household surfaces.
Specifications
-
Power adapter input voltage: 100–240 VAC, 50/60 Hz.
-
Power adapter output voltage: 25.9 VDC, 0.5 A.
-
Nominal battery voltage: 22.2 VDC.
-
Battery: li-ion.
-
Battery capacity: 2000 mAh.
-
Charging time: 5 hours.
-
Power: 350W.
-
Thrust power: 8 kPa (low power), 23 kPa (high power).
-
Noise level: 64 dB.
-
Operating time: up to 12 minutes (turbo mode), up to 45 minutes (normal
mode). -
Dimensions: 1060mm × 230mm × 218mm.
-
Net weight: 1.4 kg. LED display.
Package Contents
See picture a:1 vacuum cleaner housing, 2 battery pack, 3 MIF- filter, 4 extension tube, 5 charging base, 6 power adapter, 7 wall mounting kit (two screws, two dowels), 8 roller brush, 9 crevice brush, 10 flat brush, quick start guide, warranty card.
Limitations and Warnings
WARNING! The battery can only be charged using the original power adapter. Use of a non-original power adapter (charger) voids the manufacturer’s warranty. Do not use the charger to power or recharge any and all incompatible devices. The manufacturer is not liable for any consequences caused by the use of the power adapter for purposes other than its intended use or for powering or recharging a device not included in the scope of delivery. Make sure the cleaner is disconnected from the power adapter before performing maintenance. Do not immerse the cleaner or any part of it in water or any other liquid. Do not use aggressive or easily flammable detergents to care for the vacuum cleaner. Clean the vacuum cleaner filter regularly. Disconnect the power adapter after fully charging. Do not install the wall bracket in locations exposed to direct sunlight or excessive heat. Do not use the power adapter if the plug or cord is damaged. Do not attempt to vacuum flammable objects (cigarette butts, matches, ashes) or excessively crushed construction debris (e.g., lime, cement, plaster powder), large sharp objects and fragments (e.g., glass, nails, needles), aggressive liquids (solvent, cleaner, acids), flammable or explosive liquids (e.g., gasoline, alcoholic products). Keep hair, loose clothing, fingers and other body parts away from the air duct and moving parts of the cleaner. Do not point vacuum cleaner air tube, handle or other tools at eyes, ears or other sensitive areas of the body. Carefully examine the area to be cleaned before turning on the vacuum cleaner. If it contains large pieces or lumps of paper, plastic or cloth, sharp objects, or objects larger than the diameter of the vacuum cleaner tube, remove them from the cleaning area beforehand. Otherwise, the tube of the vacuum cleaner may get clogged, which will decrease its suction power. If the cleaner gets too hot, you hear an abnormal sound, the suction power has decreased, or there is an unpleasant odor, stop using it immediately. Inspect the dust container regularly. If there is a lot of rubbish and dust in it, clean it out.
Assembly and operation
Attach the extension tube 4 to the vacuum cleaner housing , 1 pushing
the tube into the slot until it clicks into place. To the other end of the
extension tube, attach one of the brushes 8 , 9 or 10, insert the
brush into the groove of the tube until it clicks into place (see figure
c). You can also attach the brushes directly to the vacuum cleaner housing
(without the metal extension tube). You must charge the vacuum cleaner before
using it for the first time. To do this, attach the charging base 5
together with the power adapter 6 rigidly attached to the wall using the
wall mount kit 7.
NOTE. The charging base should be at least 1 meter above the floor and no further than 1 meter from an AC power outlet.
Plug the power adapter into a power outlet and place the vacuum cleaner in the
charging base so that the charging base plug fits into the socket on the
handle of the vacuum cleaner housing. It takes 4–5 hours to charge the battery
fully. When the battery is fully charged, all four bars will be lit on the
battery pack indicator 16 (see figure h).
When fully charged, remove the vacuum cleaner from the charging base. To turn the cleaner on or off, press the trigger switch 17 located on the handle of the vacuum cleaner housing (see illustration a). Use the 14 button on the back of the battery pack (see figure h) to change the vacuum cleaner’s operating mode if the unit is already on. The vacuum cleaner operates in three modes: economy mode, medium mode and turbo mode. The modes are switched with the button one by one.
Table of vacuum cleaner operation modes
Vacuum cleane stater| User actions|
Result
---|---|---
The vacuum cleaner is off| Press the switch 17| The vacuum cleaner turns
on and operates in
economy mode
The vacuum cleaner is onand operates in economy mode| Click 14| The
vacuum cleaner operates in medium mode
The vacuum cleaner operates in medium mode| Press 14 one more time| The
vacuum cleaner operates in turbo mode
The vacuum cleaner operates in turbo mode| Press 14 one
more time
| The vacuum cleaner operates in economy mode
The vacuum cleaner operates in any mode| Press the switch 17| The vacuum
cleaner turns off
Before cleaning the dustbag housing 18 , disconnect it from the vacuum
cleaner housing by pressing the round button on the dustbag housing end (see
figure f). Press the latch 19 to open the bottom lid of the dustbag
housing is opened. Shake dust and other rubbish out of the dustbag housing.
The MIFfilter is to be flushed with water at least once every three months
3. To do this, pull the MIF filter out of the dustbag housing (see
figure g). Then remove the filter 12 and the overlay 13 from the
funnel of the MIF filter 11. Rinse the MIF filter parts with running water
and dry them. Then assemble the MIF filter and insert it into the dustbag
housing. Put the dustbag housing back into place in the vacuum cleaner
housing.
The roller brush 8 requires regular cleaning of trapped hair and other
rubbish. To do this, turn the brush lock on the right side (see figure e)
by a screwdriver or knife. Then remove the clogged brush roll and clean it.
Use only a special brush for this. Do not wash the roller with water or
cleaning detergents and do not remove rubbish with your fingers.
Troubleshooting
The vacuum cleaner does not turn on. Possible causes: low charge level, clogging. Solution: charge the battery, clean the clogs.
Weak suction power. Possible causes: overfilled dustbag, clogged brush. Solution: clean the dustbag, filters and the brush. Strong noise, extraneous sounds. Possible causes: clogged metal extension tube. Solution: clean the tube.
The main brush roll does not rotate. Possible causes: clogging. Solution: disassemble the main brush, remove the roller and the clog.
The LED indicator lights up blue, then it starts blinking red and the cleaner shuts off. Possible causes: the battery has overheated or over cooled because the room temperature is too high or too low. Solution: use the vacuum cleaner at temperatures between 0 °C and +40 °C. The charge indicator does not change its reading during charging. Possible causes: non-original power adapter used, the battery is out of order. Solution: Use only the original power adapter to charge the vacuum cleaner.
ATTENTION! If your problem persists, please contact your local supplier or the service center for support. Please do not disassemble the device or try to repair it on your own.
Recycling information
These symbols indicate that you must follow the Waste Electrical and
Electronic Equipment (WEEE) and Waste Battery and Battery Regulations when
disposing of the device, its batteries and accumulators, and its electrical
and electronic accessories. According to the rules, this equipment must be
disposed of separately at the end of its service life. Do not dispose of the
device, its batteries and accumulators, or its electrical and electronic
accessories together with unsorted municipal waste, as this will harm the
environment. To dispose of this equipment, it must be returned to the point of
sale or turned in to a local recycling facility.
You should contact your local household waste disposal service for details.
Warranty
The warranty period and service life shall be 2 years as from the date of
purchase of the device.
Manufacturer: ASBISc Enterprises PLC, 43 Kolonakiou Street, Diamond
Court, Ayios Athanasios, 4103 Limassol, Cyprus. Made in China.
For current information and details on the device description and specification, as well as connection process, certificates, warranty and quality issues, see relevant Installation and Operation Manuals available for downloading at aeno.com/documents. All trademarks and names herein are the property of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>