Fontastic Kari 10 Power Bank User Manual
- June 5, 2024
- fontastic
Table of Contents
Fontastic Kari 10 Power Bank
Please read these instructions carefully before using the device.
Package contents
- Fontastic® power bank Kari
- USB cable with multi-connector
- User manual
Overview
- Battery level indicator
- Multi connector (Micro USB, Type-C, 8-pin)
- USB cable
- USB-A plug/slot
- Battery status button
- Micro USB input
- USB Type-C input
- USB output
- Multi connector slot
Charge power bank
The Fontastic® Powerbank Kari is equipped with a rechargeable lithium-polymer
battery. Connect the power bank to a USB charger via the Micro-USB (6) or
Type-C (7) input. The cable can be connected to any charger with USB output.
The battery level indicator (2) flashes during charging. When fully charged,
the indicator is at 100%. The charging process is completed. Disconnect the
power bank from the charger.
Note: Fully charge the power bank before using it for the first time. The
usual charging time is approx. 4 hours, but this may vary depending on the
used USB charger.
Check the battery level of the power bank
To check the battery status, press the battery status key (5). The LED
indicator (1) lights up for a few seconds and shows the battery level of the
power bank in 25% steps. 100% means that your power bank is fully charged, and
25% means that it is almost empty and should be changed promptly.
Charge devices using the power bank
To charge devices via the power bank, pull the plugs of the charging cable
integrated into the housing out of the slots (4,9). Remove the cable (3) from
the case and insert the USB plug of the cable into the USB-A output (8) of the
power bank. Connect the matching plug of the multi-connector with Micro USB,
Type-C and 8-pin connector (2) to the device to be charged. The charging
process will begin. Disconnect the cable from the power bank after use.
Note: If there is a short circuit while charging a device, the power bank
will turn off. Plug the micro-USB cable into the power bank Micro-USB input,
and connect the USB plug on the cable to a USB charger or computer. A short
charge pulse is sufficient to reactivate the power bank.
In case you need technical support, please contact our support team by e-mail
at
service@fontastic.eu.
Technical data
- Material Housing: ABS + PC
- Input: 5V DC 2A (Micro USB/USB Type-C)
- Output: 5V DC 2A (USB-A)
- Battery: 10.000 mAh 37 Wh/3.7V
- Built-in cable with combo connector (USB-A/Micro USB/8-pin/Type-C)
- LED charge level indicator
- Dimensions: 154 x 70 x 17mm
- Weight: 215g
Safety advice
- Do not open the device
- Do not hold the device underwater
- Keep it safe from humidity
- Do not connect the power output to the power input or vice versa
- Do not connect the adapter to the device by using force
- Keep the device away from children
- Disconnect electronic devices from the power when not using them for a longer time.
- Do not use the device when it has visible defects