Fontastic Paso Wireless Speaker with 360 Degree LED light Show User Manual

Wireless speaker with 360° RGB light show

User manual

Thank you for choosing Paso wireless speaker.
Please read the operating instructions carefully and observe the safety instructions.

Package contents

• BT Speaker Paso
• USB charging cable
• Hand strap
• Instruction manual

Overview:

1. 360° RGB lighting
2. Microphone
3. Previous Title / Volume –
4. Play/Pause – On/Off button
5. Light/Mode Button
6. Next Title/ Volume +
7. Micro SD card slot
8. USB Type-C charging port
9. Status LED

Commissioning

Charging the battery
Paso is equipped with an internal rechargeable lithium-ion battery. Connect the USB cable, which is included, to the USB Type-C charging port (8) of the Paso. The USB-A plug of the cable can be connected to a computer or USB power supply. The status LED (9) lights up during charging. When fully charged, the LED goes out.

Note: If the battery is less than 10%, the speaker will give a voice prompt. When the battery is less than 3%, the device automatically turns off.

Attention: Charge the speaker for at least 2.5 hours before first use. Switch on/off

Switch on: Press and hold the Power button for three seconds. The 360° RGB lighting illuminates and the voice announcement sounds.

Switch off: Press and hold the Power button for three seconds. The voice prompt sounds.

Pairing

The speaker must be paired with a Bluetooth device before it can be used for wireless music streaming.

1. Switch on the Speaker. The voice prompt sounds, indicating that the speaker is in pairing mode.
2. Search for Bluetooth r audio devices with your Bluetooth® device from which audio data is to be played.
3. The searching Bluetooth’ device indicates that it has the speaker „ Paso ” has been found. Confirm the pairing with „ Paso “. A successful connection is confirmed by the voice announcement.

When using a Bluetooth- device without a display, switch it to pairing mode and wait a few seconds. Wait for seconds until the connection with the speaker is established.

Note: If the connection is lost or the transmitter is disconnected for a short time, the Paso automatically tries to re-establish the connection.

TWS function

With the TWS function, you can connect two Paso speakers together to output your music through two speakers.
To connect two Paso, turn on both devices. Press the mode button one of the speakers two times. The two devices connect to each other. An acoustic signal indicates a successful connection.
Press the mode button one of the speakers two times to exit this mode.

Music playback

Play music via Bluetooth
A Bluetooth® source must be paired with Paso to receive and output music wirelessly!

Note: The phone must support A2DP and AVRCP profile to play and control music through the Paso.

Music control
Play or pause music , briefly press the Play/Pause button .
Skip to the next track , press and hold the Next Title button for one second.
Skip to the previous track , press and hold the Previous Track button for one second.

Playback from Micro SD card

1. Place a Micro SD card in the card slot (7) of the Paso with the contacts facing up.
2. The card mode will start automatically and the music will be played. Press the mode button for two seconds to switch between BT and card mode.

Note: You need to insert a Micro SD card to change the mode. When the speaker is turned on, it will automatically start in BT mode.

Hands-free function

A built-in microphone (2) makes the speaker suitable to be used as a hands- free speaker for phone calls.

Note: High volume may cause feedback with the microphone. This results in echo on the phone side, not on the speakerphone side.

Accept/end/reject calls
To answer an incoming call, press the Play/Pause button once.
To end a call in progress, press the Play/Pause button once.
To reject incoming calls, double click the Play/Pause button .
Redial, press the Play/Pause button twice. The last number dialed will be called again.

RGB lighting

Paso is equipped with 360° RGB lighting. Pressing the light/mode button briefly changes the lighting mode.
By pressing the light/mode button twice the lighting is switched off.

Volume setting

Increase volume: Press the Volume+ button repeatedly until the desired volume is reached.
Decrease volume : Press the Volume- button repeatedly until the desired volume is reached.

Technical data

• Features: BT speaker with TWS and 360° LED light, card reader, speakerphone.
• Housing Material: ABS + Metal
• BT: 5.1
• Profiles: HSP/HFP/A2DP/AVRCP
• Audio decoding: SBC/MP3/WMA/FLAC/MP4/M4A
• Speaker: 5W max / 4Ω
• Driver size: Φ52mm
• Frequency response: 50Hz-12kHz
• Sensitivity: +38±2dB
• Battery capacity: 600mAh
• Operating voltage: 3.0-4.2V
• Input for charging: 5VDC
• Charging port: USB Type-C
• Operating time: Up to 6 hours (70% volume)
• Charging time: 1.5 hours
• Standby time / Connected: 48 hrs.
• Weight: 215g

No liability is accepted for any damage which may occur through improper operation.

If you require technical support, please contact our support team via email at service@fontastic.eu.

Registration and Safety

Certification/General Information

We hereby declare, that this device carries the CE mark in accordance with the regulations and standards. It conforms with the fundamental requirements of the RED 2014/53/EU, as well as the RoHS Directive 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: www.d-parts.de/Konfo

Note on environmental protection:

After the implementation of the European Directive 2012/19/EU in the national legal system, the following applies: Electrical and electronic devices may not be disposed of with domestic waste. Consumers are obliged by law to return electrical and electronic devices at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details of this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, re-using the materials or other forms of utilising old devices, you are making an important contribution to protecting our environment.

Improvement and changes of the technical specifications and other data’s could be made without prior notice.
Registered trademarks are the property of their respective owners.

Fontastic, by D-Parts GmbH
Birkenweiher Str. 16 • 63505 Langenselbold, Germany,www.d-parts.de

V1_0822

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>