Somogyi Elektronic FKH 401 Electronic thermostat Instruction Manual
- June 5, 2024
- SOMOGYI ELEKTRONIC
Table of Contents
FKH 401
Instruction manual
Safety and maintenance 
This product is suitable for heating only well-insultated spaces or for occasional use!
Figure 1
Figure2
| STRUCTURE (Figure 1.)
---|---
1| cold air inlet
2| hot air outlet
3| main switch
4| display
5| cozy flame effect
6| thermostat temperature setting
7| unit on/off switch
8| flame effect on/off switch
9| shut-off timer
10| mains plug
PORTABLE MINI CERAMIC HEATER
IMPORTANT SAFETY INSTRUCTIONS
READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USE AND RETAIN IT FOR LATER
REFERENCE!
WARNINGS
-
Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were written in the Hungarian language.
-
Children below the age of 3 years should be kept away from the appliance, except where they are under constant supervision. Children between the age of 3 and 8 may only switch the appliance on/off provided that it has been set up and installed in the normal operating position and they are under supervision or have been instructed how to operate the appliance safely and understand the hazards associated with use. This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given instruction concerning the use of the appliance by a person responsible for their safety and they have understood the hazards associated with use. Children should not be allowed to play with the unit. Children may only clean or perform user maintenance on the appliance under supervision.
WARNING: Parts of this appliance can become very hot and could cause burns. Extra care should be taken when children or handicapped persons are around. -
Confirm that the appliance has not been damaged in transit.
-
Do not use this heater if it has been dropped.
-
Do not use it if there are visible signs of damage to the heater.
-
Never locate the unit directly in corners and observe the minimum mounting distances indicated in Figure 2.
Always observe the health and safety regulations valid in the country of use. -
The appliance must not be used with programmable timers, timer switches, or stand-alone remote-controlled systems that can automatically turn the unit on because any covering or improper location of the unit can cause a fire hazard.
-
The appliance should be used as intended for heating air, not for general heating purposes.
-
The stream of hot air should not be directed to curtains or other flammable materials.
-
The grill covering the hot air outlet opening can be hot.
-
Do not locate near flammable materials. (min. 100 cm)
-
Do not locate near flammable materials. (min. 100 cm)
-
Do not use in locations where flammable vapors or explosive dust may be present. Do not use near flammable materials or in potentially explosive atmospheres!
-
Operate only under constant supervision.
-
Do not operate unattended in the presence of children.
-
Only for indoor use, in a dry place. Protect from humidity (e.g. bathrooms, swimming pools)!
-
It is PROHIBITED to use the unit near bathtubs, basins, showers, swimming pools, or saunas.
-
It is prohibited to use the appliance in motor vehicles or in tight (< 5 m²) spaces such as elevators)!
-
When not planning to use the unit for an extended period of time, switch it off then remove the power plug from the power outlet.
-
Before moving the heater, always unplug it from the power outlet.
-
If any irregular operation is detected (e.g., unusual noise or burnt odor from the unit), immediately switch it off and remove the power plug.
-
Make sure that no foreign objects or liquid can enter the unit through the openings.
-
Protect from dust, humidity, sunlight, and direct heat radiation.
-
Power off the unit by unplugging it from the electric outlet before cleaning.
-
Do not touch the unit or the power cable with wet hands.
-
The appliance may only be connected to properly grounded 230 V~/50 Hz electric wall outlets!
-
Do not use extension cords or power strips to connect the unit.
-
The appliance should be located so as to allow easy access and removal of the power plug.
-
The unit is intended for household use, no industrial use is permitted.
-
Due to continuous improvements the design and specifications may change without any prior notice.
-
The actual instruction manual can be downloaded from www.somogyi.hu website.
-
We do not take the responsibility for printing errors and apologize if there are any.
DO NOT COVER! COVERING THE UNIT CAN CAUSE
OVERHEATING, FIRE, OR ELECTRIC SHOCK.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case
any part is damaged, immediately power off the unit and seek the assistance of
a specialist.
INSTALLATION
- Before switching it on for the first time, carefully remove the packaging material taking care not to damage the appliance and power cable. Do not use the product if it is damaged in any way.
- The unit may only be used indoors in dry conditions.
- To ensure the proper operation of the appliance, you have to arrange for the free circulation of hot air. Therefore, please, take into consideration the minimal placement distances shown in Figure 2.
- The main switch of the appliance (3) must be set in the „0” (OFF) position.
- The appliance’s power plug can be rotated at 90 degrees after pressing the power plug latch (10) button. The appliance can only be operated if the power plug is fixed in one of the two end positions.
- Connect the unit’s power cable to a standard grounded wall outlet. This completes the setup of the unit, which is ready for operation.
CLEANING, MAINTENANCE
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.
- Switch off and power off the unit by unplugging it from the electric outlet before cleaning.
- Let the appliance cool down (min. 30 minutes).
- Use a vacuum cleaner to clean the air inlet (1) and outlet (2) openings.
- Use a slightly moistened cloth to clean the unit’s outer surface. Do not use aggressive cleaners. Avoid getting water inside onto the electric components of the appliance.
TROUBLESHOOTING
| Malfunction | Possible solution |
|---|---|
| The appliance does not heat. | Check the section on overheating protection. |
Check the power supply.
Check the section on the thermostat.
Overheating protection activates frequently.| Clean the appliance.
DISPOSAL
Waste equipment must be collected and disposed of separately from household
waste because it may contain components hazardous to the environment or
health. Used or waste equipment may be dropped off free of charge at the point
of sale, or at any distributor which sells equipment of identical nature and
function. Dispose of products at a facility specializing in the collection of
electronic waste. By doing so, you will protect the environment as well as the
health of others and yourself. If you have any questions, contact the local
waste management organization. We shall undertake the tasks pertinent to the
manufacturer as prescribed in the relevant regulations and shall bear any
associated costs arising.
Functions
FEATURES
Ceramic fan heater for heating indoor air
- 400 W output
- modes: cold or hot air
- electronic thermostat
- overheating protection
- cozy flame effect
- digital display
OPERATION
Activate the device by using the main switch (3). The device display will show „- -”. Then you can turn the device on or off by using the switch (7) on the top. When switched on, the display shows „HH” and the device switches to heating mode. Its operation is then independent of the thermostat.
Use the thermostat control buttons (6) to set the desired temperature between 15 and 45 °C. If the ambient temperature drops 1 °C below the set value, the device switches to heating mode. If the ambient temperature exceeds the set value by 1 °C, the heating element in the appliance turns off, while the fan continues to run. When the set temperature is lower than the ambient temperature, the set value continuously flashes on the device display.
While the device is in operation, you can switch on or off the cosy flame effect at any time (8).
You can set a shut-off time within up to 12 hours by using the device shut-off timer (9). Set the desired value by repeatedly pressing the button, and the device will shut off automatically after the set time has elapsed.
You can switch off the device at any time by pressing the on/off button (7). In this case, the device continues to operate in fan mode for half a minute, and the display shows a countdown. Do not disconnect the unit, until it stops completely. This may cause damage to the unit!
Overheating protection serves to switch off the device in the event of overheating, e.g., if the air inlet or outlet is blocked. Disconnect the device by pulling out the main plug. Let the device cool down (min. 30 minutes). Check if the air inlet and outlet are unblocked; clean them if necessary. Turn on the device again. If the overheat protection keeps activating, disconnect the device by pulling out the mains plug and contact an authorized service shop.
SPECIFICATIONS
Power supply: …………………..230 V / 50 Hz
output:……………………………..400 W
IP protection: IP20: Not protected against the ingress of water.
dimensions of heater: ………..9,5 x 18,5 x 7 cm
sound pressure: ………………..58 dB(A)
Producer
SOMOGYI ELEKTRONIC
H – 9027 • Győr, Gesztenyefa út 3. •
www.somogyi.hu
Distribútor: SOMOGYI ELEKTRONIC SLOVENSKO s.r.o.
Ul. gen. Klapku 77, 945 01 Komárno, SK • Tel.: +421/0/ 35 7902400 •
www.somogyi.sk
Distribuitor: S.C. SOMOGYI ELEKTRONIC S.R.L.
J12/2014/13.06.2006 C.U.I.: RO 18761195
Cluj-Napoca, judeţul Cluj, România, Str. Prof. Dr. Gheorghe Marinescu, nr. 2,
Cod poştal: 400337
Tel.: +40 264 406 488, Fax: +40 264 406 489 •
www.somogyi.ro
Producător: Somogyi Elektronic Kft
Uvoznik za SRB: ELEMENTA d.o.o.
Jovana Mikića 56, 24000 Subotica, Srbija • Tel:+381(0)24 686 270 •
www.elementa.rs
Zemlja uvoza: Mađarska • Proizvođač: Somogyi Elektronic Kft.
Uvoznik za HR: ZED d.o.o.
Industrijska c. 5, 10360 Sesvete, Hrvatska • Tel: +385 1 2006 148 •
www.zed.hr
Uvoznik za BiH: DIGITALIS d.o.o.
M.Spahe 2A/30, 72290 Novi Travnik, BiH • Tel: +387 61 095 095 •
www.digitalis.ba
Proizvođač: Somogyi Elektronic Kft, Gesztenyefa ut 3, 9027 Gyor,
Mađarska
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>