SOMOGYI ELEKTRONIC DB 1002AC/M Wireless Doorbell Set and Night Light Instruction Manual

SOMOGYI ELEKTRONIC DB 1002AC/M Wireless Doorbell Set and Night Light

PRODUCT SPECIFICATION

• Operation range in open area: approx. 100 m
• Can be used even with 4 push- buttons
• Separately switchable cold white night light function
• Polyphonic, pleasant sound
• 8 varied, well-known melodies
• Flashing blue light indication at the same time with the voice signal
• Operation indicator blue LED
• Strongly interference protected from other doorbells
• IP44 protected bell push
• Unique encoding with learning function
• 256 digital codes are available
• Operation frequency: 433,92 MHz
• Doorbell power supply: 230V-/50Hz
• Bell push power supply: 1x 3V CR2032, included

INSTALLATION

• Bell push is delivered with CR 2032 (3V) button cell. Remove the insulation piece, if there’s any.
• Insert the doorbell to a standard 230 V-/50 Hz socket. 1The doorbell is ready for use, if the blue operation indicator LED on its front is lit. Pair the two units with each othe.

PAIRING, SETTING DIGITAL CODE

When pairing the bell, it learns a randomly generated operating code and memorizes it to the push-button. This code will not be forgotten even in the event of blackouts, and will be automaticlly re-set to the push-button.

1. Press the push-button once to generate a new code. The sound-out of the bell means recording tne new code.

2. To teach a 2. push-button: Hold pressed the CODE signed button on the side of the bell, until you hear an acoustic signal. The bell is now ready to receive the new code Press the second push button within 5 seconds after the acoustic signal. The new push- button then sends signal to the bell, which sounds-out an acoustic signal itf it successfully memorized the operating code.

3. To add additional push-buttons: Repeat the steps written at the 2. point with the 3. and

4. push-buttons, which are the same type with the 3. and 4. attachment wanted to be paired. Ihe bell unit can maximum handle 4 push-buttons simultaneOusly. f no button is pressed within 5 seconds, an error message Is be heard.

5. To delete the stored operating codes: Remove the batteries from the push-buttons that are already taught to the bell. Disconnect the bell from the power socket. Reconnect the bell to the power socket, and hold pressed the CODE button. The bell indicates with fwo beep that code-learning function is active again.
   IMPORTANT: Do not delete the operating codes or rewrite them before replacing the batteries in the push-buttons!
   Caution: If the bell sounds out acoustic signal for no reason during the process, this means thata similar bell’s operation bothered the process. In this case, delete the leamt operating cOde according to the 4. point, then repeat the teaching process.

   • Ater one push of the button, the melody will be played at one time, holding the button pushed will not cause the repeating of the melody.
   • By repeatedly pressing the,S” (selector) button on the backside of the bell push, near the button cell, select the desired melody. Then this melody will sound at every ringing. After the button-cell is removed, the melody switches to the factory default setting and the two uníts need to be paired again.

NIGHT LIGHT

You can switch on and off the night light function of the appliance with the ON-OFF slide switch located on the side. When the device is switched on and the sensor at the bottom is not detecting light, the bell will automatically light up with cold light. This does not affect the traditional functions of the bell.

CLEANING

In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination. Use a soft, dry cloth for cleaning. Do not use any aggressive cleaners and liquids.

WARNINGSs

• Bells or electrical appliances operating in the vicinity of the doorbell may cause random ringing. pairing the units again.
• After changing the batteries, pairing and melody selection must be repeated! In case of a pairing problem, remove the batteries for a short time. Also remove the batteries if you do not use the appliance for a long time.
• Electrostatic discharge can cause memory loss. In this case, pair the units again.
• In case of decreasing operation range, replace the batteries. Battery capacity may decrease in cold weather. Do not use different brands and/or different capacity batteries! Do not use rechargeable batteries!
• Walls, metal objects as well as radio frequency operated equipment can decrease the operation range. Do not place the bell push on metal or UPVC door frame!
• The doorbell is designed for indoor use! Protect it from wet, humidity, heat, frost, shocks and direct sunshine as well! Do not locate it in the kitchen or in bathroom. The outdoor unit has to be mounted to a place which is protected from direct rain and sunshine.
• Somogyi Elektronic Ltd. certifies, that this radio-equipment conforms to 2014/53/EU directive. Fll text of EU Declaration of conformity is available at the following addresS: www.somogyi.hu
• WARNING! RISK OF EXPLOSION IN CASE OF INCORRECT BATTERY REPLACEMENT! IT CAN BE DONE ONLY BY SAME OR REPLACING TYPE! DO NOT EXPOSE BATTERIES TO DIRECT THERMAL RADIATION AND SUNSHINE! DO NOT BURN THE BATTERIES! IF THERE IS SOME LIQUID FLOWN OUT FROM THE BATTERY, TAKE A PROTECTIVE GLOVE, AND CLEAN THE BATTERY HOLDER WITH A DRY CLOTH! KEEP BATTERIES OUT OF REACH OF CHILDREN! IT IS FORBIDDEN TO OPEN, BURN AND SHORT-CIRCUIT AND CHARGE BATTERIES! RISK OF EXPLOSION!!
• THIS PRODUCT INCLUDES BUTTON CELL. DO NOT SWALLOW THE BATTERY, RISK OF CHEMICAL BURN! IN CASE OF INGESTION, IT CAN CAUSE STRONG INTERNAL BURN WITHIN 2 HOURS AND MAY LEAD TO DEATH! KEEP THE NEW AND USED BATTERIES OUT OF REACH OF CHILDREN! IF THE COVER OF BATTERY COMPARTMENT CANNOT CLOSE PROPERLY, DO NOT USE THE PRODUCT MORE, AND KEEP OUT OF CHILDREN! IF YOU THINK A BATTERY HAS BEEN SWALLOWED OR GOT INTO ONE OF THE BODY PARTS, IMMEDIATELY CONSULTADOCTOR!

DISPOSAL

• Waste equipment must be collected and disposed separately from household waste because it may contain components hazardouS to the enVironment or health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of the product at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourselt. If you have any questions, contact the local waste management organization. We shall manufacturer as prescribed in the relevant regulations and shall bear any associated costs arising.
• DISPOSING OF ALKALINE AND RECHARGEABLE BATTERIES
• Batteries, whether alkaline or rechargeable, must not be handled together with regular household waste. It is the legal obligation of the product’s user to dispose of batteries at a nearby collection center or at a retail shop. This ensures that the batteries are ultimately neutralized in an environment-friendly way.

BATTERIES INSTALLATION

ABOUT COMPANY

• Producer: SOMOGYI ELEKTRONIC.H-9027 Győr, Gesztenyefa üt 3.
• www.somogyi.hu
• Distribútor. SOMOGYI ELEKTRONIC SLOVENSKO S. r. o.
• Ul. gen. Klapku 77, 945 01 Kománo, SK
• Tel.: +421/0/35 7902400
• www.somogyi.sk
• Distribuitor: S.c. SOMOGYI ELEKTRONIC S.R.L.
• 12/2014/13.06.2006 C.U.I: RO 18761195
• Cluj-Napoca, județul Cluj, România, Str. Prof. Dr. Gheorghe Marinescu, nr. 2, Cod poştal: 400337
• Tel.: +40 264 406 488,
• Fax: +40 264 406 489
• www.somogyi.ro
• Uvoznik za SRB: ELEMENTA d.o.o.
• Jovana Mikiča 56, 24000 Subotica, Srbija
• Tel:+381(0)24 686 270
• www.elementa.rs
• Zemlja uvoza: Mađarska Zemlja porekla: Kina Proizvodač: Somogyi Elektronic Kft.
• Uvoznik za HR: ZED d.o.0.
• Industrijska c. 5, 10360 Sesvete, Hrvatska
• Tel: +385 1 2006 148
• www.zed.hr
• Uvoznik za BiH: DIGITALIS d.o.o.
• M.Spahe 2A30, 72290 Novi Travnik, BiH
• Tel: +387 61 095 095
• www.digitalis.ba
• Proizvodač: Somogyi Elektronic Kft, Gesztenyefa ut 3, 9027 Gyor, Madarska

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>