SOMOGYI ELEKTRONIC IPX4 PORTABLE FAN HEATER Instruction Manual
- June 5, 2024
- SOMOGYI ELEKTRONIC
Table of Contents
instruction manual
This product is suitable for heating only well-insulated spaces or for occasional use!
Safety and maintenance
Functions
figure 1.
figure 2
figure 3
STRUCTURE
(Figure 1.)
- cold air inlet
- warm air outlet
- thermostat
- carrying handle
- operation mode switch
- powerline connector
PORTABLE FAN HEATER
I MPORTANT SAFETY INSTRUCTIONS
READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USE AND RETAIN IT FOR LATER
REFERENCE!
WARNINGS
-
Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were written in the Hungarian language.
-
Children below the age of 3 years should be kept away from the appliance, except where they are under constant supervision. Children between the age of 3 and 8 may only switch the appliance on/off provided that it has been set up and installed in the normal operating position and they are under supervision or have been instructed how to operate the appliance safely and understand the hazards associated with use. This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given instruction concerning use of the appliance by a person responsible for their safety and they have understood the hazards associated with use. Children should not be allowed to play with the unit. Children may only clean or perform user maintenance on the appliance under supervision.
WARNING: Parts of this appliance can become very hot and could cause burns. Extra care should be taken when children or handicapped persons are around. -
Confirm that the appliance has not been damaged in transit.
-
Do not use this heater if it has been dropped.
-
Do not use if there are visible signs of damage to the heater.
-
Never locate the unit directly in corners and observe the minimum locating distances indicated in Figure 2. Take into consideration the valid safety regulation of the county of use!
-
The appliance must not be used with programmable timers, timer switches or stand-alone remote-controlled systems that can automatically turn the unit on because any covering or improper location of the unit can cause a fire hazard.
-
The appliance should be used as intended for warming air, not for general heating purposes.
-
The stream of warm air should not be directed to curtains or other flammable materials!
-
The entire surface of the heater may be hot!
-
Do not place it close to flammable materials! (min. 100 cm)
-
Do not use in locations where flammable vapors or explosive dust may be released! Do not use near flammable materials or in potentially explosive environments!
-
Operate only under constant supervision!
-
It is forbidden to use it near children unattended!
-
It is PROHIBITED to use the unit near bathtubs, basins, showers, swimming pools or saunas!
-
It is STRICTLY PROHIBITED to use the install and use the appliance in zone 0 or 1 of premises containing a bathtub or shower (see figure 3.)!
-
In rooms with a bathtub or shower, all circuits must be protected by one or more circuit-breakers (RCDs) with a nominal tripping current up to 30 mA!
-
When installing the appliance in rooms with bathtubs or showers, observe local special national regulations.
-
It is prohibited to use the appliance in motor vehicles or in tight (< 5 m 2 ) spaces (such as elevators)!
-
When not planning to use the unit for an extended period of time, switch it off then remove the power plug from the outlet. Store the appliance in a cool, dry place!
-
Before moving the heater, always unplug it from the mains!
-
It is only possible to move it by the carrying handle!
-
It is not allowed to locate the appliance directly below a wall outlet!
-
If any irregular operation is detected (e.g. unusual noise or burnt odor from the unit), immediately switch it off and unplug it!
-
Make sure that no foreign objects or liquid can enter the unit through the openings!
-
Protect from dust, humidity, sunlight, and direct heat radiation!
-
Unplug the unit from the mains before cleaning!
-
Never touch the appliance and the power cable with wet hands!
-
May only be connected to ground, 400 V~ / 50 Hz, 3P+N+E socket!
-
Unwind the power cable totally!
-
Do not lead the power cable on the appliance or near the air-in and outlet vents!
-
Do not lead the power cable under carpets, doormats, etc.!
-
The appliance should be located so as to allow easy access and removal of the power plug!
-
Lead the power cable so as to prevent it from being pulled out accidentally or tripped over!
-
Due to continuous improvements, the technical data and design may change without any prior notice.
-
The actual instruction manual can be downloaded from the www.Somogyi.hu website.
-
We don’t take the responsibility for printing errors that may occur, and apologize for them.
DO NOT COVER! COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE, OR ELECTRIC
SHOCK.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case
any part is damaged, immediately power off the unit and seek the assistance of
a specialist.
INSTALLATION
- Before switching on for the first time, carefully remove the packaging material taking care not to damage the appliance. Do not use the product if it is damaged in any way!
- The unit may only be used indoors in dry conditions!
- Set the appliance on a stable and horizontal surface! The free flow of warm air must be ensured for proper operation, therefore, please note the minimum installation distances indicated in figure 2.
- Verify that the appliance’s mode switch (5) is in of „0” position!
- Only use standard 3P+N+E socket and power cable, with a minimum load of 400 V and 3 x 16 A.
- Connect the appliance to a standard grounded 3P+N+E wall outlet! This makes the appliance ready for use.
CLEANING, MAINTENANCE
In order to ensure optimum functioning, the unit may require cleaning at least
once a month, depending on the manner of use and degree of contamination.
- Switch off and power off the unit by unplugging it from the electric outlet prior to cleaning!
- Allow the appliance to cool (for at least 30 minutes).
- Use a vacuum cleaner to clean the air inlet (1) and outlet (2) openings!
- Use a slightly moistened cloth to clean the unit’s exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the appliance.
TROUBLESHOOTING
| Malfunction | Possible solution |
|---|---|
| The appliance does not heat. | Check the section on overheating protection. |
Check the fan operation mode.
Check the settings of the operation mode switch.
Check the power supply.
Check the section on the thermostat.
The appliance does not blow,, cold air’ | Set the thermostat to maximum.
Overheating protection activates frequently.| Clean the appliance.
DISPOSAL
Waste equipment must be collected and disposed of separately of household
waste because it may contain components hazardous to the environment or
health. Used or waste equipment may be dropped off free of charge at the point
of sale, or at any distributor which sells equipment of identical nature and
function. Dispose of products at a facility specializing in the collection of
electronic waste. By doing so, you will protect the environment as well as the
health of others and yourself. If you have any questions, contact the local
waste management organization. We shall undertake the tasks pertinent to the
manufacturer as prescribed in the relevant regulations and shall bear any
associated costs arising.
PORTABLE FAN HEATER
FEATURES
fan heater for heating the air of indoor premises
- 2500 / max. 5000 W output
- operation modes: cold, warm, hot air
- built-in thermostat
- overheating protection
- carrying handle
OPERATION
You can select from the following modes by using the appliance’s operation
mode switch (5):
fan and heating elements are switched off
„cold air”, only the fan is operating
the fan and both of the two heating elements are switched on
„hot air”, the fan, and all the three heating elements are switched on
The „cold air” function is independent of the settings of the thermostat.
With the thermostat (3) you can set the room’s constant temperature.
The appliance switches on at (2500 W) operation mode, as soon as the air
temperature drops below the set value. As soon as it reaches the set
temperature, the heating elements witch off. If you want a higher temperature,
turn the thermostat’s knob clockwise, if you want lower, then turn it to the
opposite direction.
The appliance operates with 5000 W output at (5000 W) operation mode,
besides the thermostat value set above the ambient temperature. If the room
temperature reaches the set temperature, the appliance switches o a low (2500
W) heating stage. If the room
temperature drops below the set value, the appliance switches again to the
high (5000 W) heating stage (5000 W). If the thermostat switches the appliance
to low heating stage resides in the high heating stage, and then you turn the
heating stage selector to stage, and the appliance switches off. After this,
if you turn the heating stage selector to stage, then the heater does not
switch on. Then if you turn the thermostat to a value higher than the room
temperature, the heater will operate at 5000 W output again.
If the thermostat is operating in the maximum value at or operation modes, and
the fan is operating but the unit does not heat, then the overheating
protection is activated. Turn the operation mode switch to the „0” position,
then power off the appliance by unplugging the connector plug. Allow the
appliance to cool (for at least 30 minutes). Check if the air inlet and outlet
openings are free; if necessary, clean them. Reinstall the appliance. If
overheating protection activates again, power off the appliance by unplugging
the connector plug and consult a qualified service center.
SPECIFICATIONS
power supply: ………………. 400 V~ / 50 Hz
output: ………………………… 2500 / 5000 W
IP protection: IPX4: Protected from splashing water (from all directions).
dimensions of heater:……. 470 x 290 x 330 mm
powerline connection: …… 3P+N+E connector plug
noise level:………………….. 60 dB(A)
producer
SOMOGYI ELEKTRONIC®
www.Somogyi.hu
Tel.: +421/0/ 35 7902400
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>