SOMOGYI ELEKTRONIC FK 31 Portable Fan Radiator Instruction Manual
- June 5, 2024
- SOMOGYI ELEKTRONIC
Table of Contents
SOMOGYI ELEKTRONIC FK 31 Portable Fan Radiator
PRODUCT OVERVIEW
PORTABLE FAN HEATER
IMPORTANT SAFETY INSTRUCTIONS
READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USE AND RETAIN IT FOR LATER
REFERENCE!
WARNINGS
- Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were written in the Hungarian language.
- Children below the age of 3 years should be kept away from the appliance, except where they are under constant supervision. Children between the age of 3 and 8 may only switch the appliance on/off provided that it has been set up and installed in the normal operating position and they are under supervision or have been instructed how to operate the appliance safely and understand the hazards associated with use. This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given instruction concerning the use of the appliance by a person responsible for their safety and they have understood the hazards associated with use. Children should not be allowed to play with the unit. Children may only clean or perform user maintenance on the appliance under supervision. WARNING: Parts of this appliance can become very hot and could cause burns. Extra care should be taken when children or handicapped persons are around.
- Confirm that the appliance has not been damaged in transit.
- Do not use this heater if it has been dropped!
- Do not use if there are visible signs of damage to the heater!
- Never locate the unit directly in corners and observe the minimum mounting distances indicated in Figure
- Always observe the health and safety regulations valid in the country of use.
- The appliance must not be used with programmable timers, timer switches or stand-alone remote-controlled systems that can automatically turn the unit on because any covering or improper location of the unit can cause a fire hazard.
- The appliance should be used as intended for heating air, not for general heating purposes.
- The stream of hot air should not be aimed directly at curtains or other flammable materials.
- The entire surface of the heater may be hot!
- Do not locate near flammable materials. (min. 100 cm)
- Do not use in locations where flammable vapors or explosive dust may be present. Do not use near flammable materials or in potentially explosive atmospheres.
- Operate only under constant supervision.
- Do not operate unattended in the presence of children.
- It is PROHIBITED to use the unit in close proximity to bathtubs, basins, showers, swimming pools or saunas.
- It is STRICTLY PROHIBITED to install or use the appliance in zones 0 and 1 of premises containing bathtubs or showers (see Figure 3)!
- All circuits in premises containing bathtubs or showers shall be protected with one or more RCDs with a rated triggering current of up to 30mA!
- Observe the local or special national regulations when installing an appliance on-premises containing bathtubs or showers.
- It is prohibited to use the appliance in motor vehicles or in confined spaces such as elevators (< 5 m2).
- When not planning to use the unit for an extended period of time, switch it off then remove the power plug from the outlet. Store the appliance in a cool, dry place.
- Always remove power from the heater before relocating it.
- Lift only by the carrying handle!
- Do not locate the appliance directly below or next to a wall outlet.
- If any irregular operation is detected (e.g., unusual noise or burnt odor from the unit), immediately switch it off and remove the power plug.
- Make sure that no foreign objects or liquid can enter the unit through the openings.
- Protect from dust, humidity, sunlight, and direct heat radiation.
- Power off the unit by unplugging it from the electric outlet prior to cleaning.
- Do not touch the unit or the power cable with wet hands.
- The appliance may only be connected to properly grounded 230 V~ / 50 Hz electric wall outlets.
- Unwind the power cable completely.
- Do not use extension cords or power strips to connect the unit.
- Do not lead the power cable on top of the appliance or near the air inlets and hot air outlets.
- Do not lead the power cable under carpets, door mats, etc.
- The appliance should be located so as to allow easy access and removal of the power plug.
- Lead the power cable so as to prevent it from being pulled out accidentally or tripped over.
- The unit is intended for household use. No industrial use is permitted.
- Due to continuous improvements, the technical data and design may change without any prior notice.
- The actual instruction manual can be downloaded from the www.Somogyi.hu website.
- We don’t take the responsibility for printing errors that may occur and apologize for them.
CAUTION: RISK OF ELECTRIC SHOCK
Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged, immediately power off the unit and seek the assistance of a specialist. In the event that the power cable should become damaged, it should only be replaced by the manufacturer, its service facility, or similarly qualified personnel.
DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE, OR ELECTRIC SHOCK.
SETUP
- Before switching it on for the first time, carefully remove the packaging material taking care not to damage the appliance and power cable. Do not use the product if it is damaged in any way.
- It is STRICTLY PROHIBITED to install or use the appliance in zones 0 and 1 of premises containing bathtubs or showers (see Figure 3)!
- All circuits in premises containing bathtubs or showers shall be protected with one or more RCDs with a rated triggering current of up to 30mA!
- Set the appliance on a stable, horizontal, and heat-resistant surface. The free flow of warm air must be ensured for proper operation, therefore, please note the minimum installation distances indicated in Figure 2.
- Verify that the unit’s mode selector (5) is in the “0” position.
- Plug the unit’s standard grounded AC power cable into a grounded wall outlet. This completes the setup of the appliance.
CLEANING & MAINTENANCE
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.
- Switch off and power off the unit by unplugging it from the electric outlet prior to cleaning.
- Allow the appliance to cool (for at least 30 minutes).
- Use a vacuum cleaner to clean the air inlet (1) and outlet (2) openings.
- Use a slightly moistened cloth to clean the unit’s exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the appliance.
TROUBLESHOOTING
| Malfunction | Possible solution |
|---|
The unit does not heat in its heating setting.
| Check the power supply.
Check the thermostat setting.
The overheating protection has activated.
The overheating protection activates frequently.| Clean the appliance.
DISPOSAL
Waste equipment must be collected and disposed of separately of from household waste because it may contain components hazardous to the environment or health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of products at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourself. If you have any questions, contact the local waste management organization. We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and shall bear any associated costs arising.