Andobil B0BJW6CWSK Easy Clip Car Mount User Guide
- June 3, 2024
- Andobil
Table of Contents
Andobil B0BJW6CWSK Easy Clip Car Mount User Guide
Specification
The parameters above are derived from the laboratory of ANDOBIL
The actual parameters would be different because of products and other
factol’!J. The Image shown here ls Indicative only.
Overview
Installation Steps
For Dashboard Use
-
Unscrew the foced nut completely, let the ball joint pessthrough the fixed nut(Thethread must face to the groove). Push the ball joint firmly into the groove on the l:)ackofthe car mount.
-
Tighten the fixed nut.
-
Hold tl,e handles and clamp the dashboard clip mount into theproper position of the dashboard to avoid blocking the view.
Velcro Instructions
The Velcro shall be used in the following 2 usage conditions.
Please choose the corresponding usage according to the shape ofyourdashboard
-
Dashboards with horizontal surface car, use directly without Velcro.
-
Dashboards with curves ere recommended to use with the Velcro.
A Insert the match-up card through the dashboard cllp mount until the triangle
marks on the match-up Cllrd is aligned with the marks on the product surface.
Remove the protective films on
the two sides of match-up card. And press slightly to fix it.
B Remove the dashboard clip mount. Tear off the protective film of the Velcro and stick itto the square cutout shown by the card. Press firmly the Velcro then remove the match-up card.
c Hold the handles and clamp the dashboard clip mount to the corresponding
position.
d. Adjust the angle of the car mount arm to fit your view.
Using Steps
-
Press the quick release button and the clamps automatically open. Then put your phone lnto the holder and pull the adjustable legs according to the size of
your phone, to ensure that your phone is clamped securely. -
Place your phone into the holder and press the clamp arms towards each other. Then press the clamp anns with a little force again until you hear the ·click”. Your
phone will be secured by the arm clamps.
Attentions
- Avoid dropping. If the car mount falls during driving, please pull over immediately, pick up the car mount and place it in a suitable position to avoid Interfering the driving.
- Do not disassemble.
- Do not install while driving.
- Do not install the car mount in places which interferes with air bag or driving.
- Keep the car mount away from chlldren.