Andobil ZJ4 Fit for Magsafe Car Mount User Guide

TEST REPORT

ZJ4 Fit for Magsafe Car Mount

REPORT No.:DTIBW20221535-3
Date:2022-08-04
Page1of7

Applicant Company Name：Shenzhen Andobil Technology Co.,Ltd.
Applicant Company Address：RM C1407,BLK C,Zhantao Technology BLDG, Intersection Of Gongye East
Road And Minzhi Road, Xinniu Community, Minzhi ST, Longhua
DIST, Shenzhen, China

The following sample(s) was/were submitted and identified on behalf of the client as:

Summary of Test Results:

Results:
Description for specimen:

A、US CaliforniaProposition 65. onLead and Cadmium content
Test method: With reference to US EPA 3052:1996/ EPA 3050B:1996,by acid digestion and analysis was performed by inductively coupled plasma atomic emission spectrometer (ICP-AES)

6
Lead (Pb)| mg/kg| 10| N.D.| 100
Cadmium(Cd)| mg/kg| 10| N.D.| 300
Conclusion| /| /| Pass| /

Note:

• N.D. = Not Detected or less than MDL
• MDL = Method Detection Limit
• mg/kg = ppm

B、US CaliforniaProposition 65.onPhthalates content
Test method: With reference to CPSC-CH-C1001-09.4, by solvent extraction and analysis was performed by gas chromatographic-mass spectrometer (GC-MS)

0.1
Diisodecyl Phthalate (DIDP)| %| 0.01| N.D.| N.D.| N.D.| N.D.| N.D.| 0.1
Di-n-hexyl Phthalate (DnHP)| %| 0.003| N.D.| N.D.| N.D.| N.D.| N.D.| 0.1
Diisononyl Phthalate (DINP)| %| 0.01| N.D.| N.D.| N.D.| N.D.| N.D.| 0.1
Conclusion| /| /| Pass| Pass| Pass| Pass| Pass| /

Note:

• N.D. = Not Detected or less than MDL
• MDL = Method Detection Limit
• % = Percentage by weight
• 0.1% = 1000mg/kg, mg/kg = ppm
• The selection of test portions is strongly recommended by the client and the conclusion of chemical test is only for the selected portion.
• Decision rule: According to DTI-CX-39-2022《Decision rule for conformity of the test results》
• All data results in this report are from report:DTIBW20221534
• Flow chart appendix is included.
• Photoappendix is included.

Appendix

Test flow chart for Lead and Cadmium content:

Test flow chartfor Phthalates content:

Photograph of Sample

This document is issued by the Company subject to its General Conditions of service of service printed overleaf, available on request for electronic format documents, subject to terms and conditions for electronic documents is drawn to the limitation of liability indemnification and jurisdiction issues defined therein. any holder of this document is advised that information contained hereon reflects the company’s findings at the time of its intervention only and within the limits of client’s instructions. if any. the company’s sole responsibility is to its client and this document does not exonerate parties to transaction from exercising all their rights and obligations under the transaction documents. this document cannot be reproduced except in full. without prior written approval of the company. any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law unless otherwise stated the results shown in this test report refer only to the sample(s)tested.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>