Andobil ZJ4 Magnetic Car Phone Holder User Guide

June 15, 2024
Andobil

Andobil ZJ4 Magnetic Car Phone Holder User Guide

Specifications

“The parameters above are derived from thelaboratory of ANDOBIL. “The actual parameters would be different because of products and other factors. The image shown here is indicative only.

Overview

Operating Instructions

This magnetic car phone mount has the following three use situations, please choose the corresponding way to use according to your mobile phone model,
DiPhone 12113 without case: Direct magnetic attraction s OK

(@ iPhone 12/13 with magnetic case: Direct magnetic attraction is oK

3 Other situations: it shall be used with metal ringThe metal ring must stick outside of the phone case. 1Phone 12713 v sbove modds ith non-magnetic case

Assembling the Metal Ring

+This product is equipped with 3 magnetic rings, please select g to the surface condition and your preference,

Note:

+ To better protect your phone, it is recommended that you paste the metal ring on the back of the phone case. – Itis recommended to use with a thin phone case vith a flat and smooth back, it is not recommended to use a phone case with an
uneven surface (such as frosted surface), which will affect the magnet effect.

  • Before use, please be sure to use the phone match-up card to
    align the position and then paste the magnetic ring to avoid misalignment and affect the wireless charging function of the phone.

Paste steps:

1. Use a cleaning wipe to clean the back of the phone (or phone case] where the metal ring needs 10 be pasted.

. Unfold the match-up card.

Align the circle of the match-up card to the center of the phone and make sure the length from the edge of the circle tothe left and right. top and bottom edges of the phoneis the same.

4.Tear off the protective paper of the metal ring and paste the metal ring onto the center of your phone/phone cese.

5. Press frmly along the magnetic Sig to secure it.

Remove the match-up card, and the installation is completed.

Note: After pasted the magnetic ring, please wait for 24 hours.

Assembling The Car Mount

1. Clean the dashboard where you need to install the magnetic holder with a cleaning kit, and wait for it to dry.

Tear off the qum release paper of adhesive from the base of the magnetic holder.

Attach the base on the cleaning area and press it frmly for more than 20 seconds to fix it.

Note: If the gum on the base is not firmly attached, please tear it off. According to the material of your car dashboard, replace the matched spare gum before sticking it (for specific usage, please tefer to the instructions of the gum sticker).
4. After standing for 24 hours, put the phone on and use it

Attentions

Far your safety, do not install or adjust the car mount while driving.
. Do not install the car mount in places which interferes with aitbag or driving.
. Before attaching the car mount, make sure the paste spot s clean and free of dust and water stain.
After sticking, let stand for atleast 24h before using. After standing for 72 hours, put the phone on the magnetic holder, it will have better stability.
5.The gum on the base can’t be reused. The accessory pack contains 2 pieces of spare gums for replacement.
. Both the two spare gums can be used, but in order to stick more firmly, please select the spare gum to match the material.
Do not knock, drop, or dismantle the product. Iis not recommended to disassemble the car mount frequently. product contains a strong magnet, which will not damage phones or tablets with solid state hard drivers. But we strongly recommend you to keep it away from credit
cards, pacemakers, or hard drives, otherwise, demagnetization might happen. 10. Keep the car mount away from children.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals