Andobil CTVK09 Wireless Car Charger Mount User Manual
- June 5, 2024
- Andobil
Table of Contents
Andobil CTVK09 Wireless Car Charger Mount
This product is a strong magnetic vehicle wireless charging electronic product. The wireless charger provides up to 15W wireless charging for compatible smartphones. It also supports EPP Qi mode. the charging power of iPhone12 and iPhone13 series mobile phones is 7.5W, and the operating frequency of the stepdown IC MP2229 is 600kHz. The NU1509 is a highly integrated wireless power transmitter digital controller that complies with the WPC 1.2.4 EPP standard with a crystal oscillator operating frequency of 22.999MHz. The NU1028 is a highly integrated fullbridge power stage IC optimized for wireless power transmitter solutions.
Working frequency: 111.0-205.0KHz.
Input: DC 5V 2A, 9V 2A, 12V 1.5A
wireless Output: 5W/7.5W/10W/15W Max
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>