Andobil CTVK51 CAR PHONE HOLDER MOUNT Instruction Manual
- June 5, 2024
- Andobil
Table of Contents
CTVK51 CAR PHONE HOLDER MOUNT
Instruction
Manualhttps://qrcodeuat.sgsonline.com.cn/openreport/viewreport/3a759b62-8c85
-4f7c-95ff-8ab8b47c7b7c
TEST REPORT
No. : GZMR220100136601
Date: Jan 21, 2022
Page: 1 of 5
CUSTOMER NAME: SHENZHEN ANDOBIL TECHNOLOGY CO., LTD.
ADDRESS: RM C1407, BLK C, ZHANTAO TECHNOLOGY BLDG, INTERSECTION OF GONGYE EAST
ROAD AND MINZHI ROAD, XINNIU COMMUNITY, MINZHI ST, LONGHUA DIST, SHENZHEN,
CHINA
Sample Name: CAR PHONE HOLDER MOUNT
Product Specification : CTVK51
Buyer: ANDOBIL Above information and sample(s) were/were submitted and
confirmed by the client. SGS, however, assumes no responsibility to verify the
accuracy, adequacy, and completeness of the sample information provided by the
client.
SGS Ref. No. : GZPH2201000528PS
Date of Receipt: Jan 17, 2022, Testing Start
Date: Jan 17, 2022, Testing End
Date: Jan 21, 2022
Test result(s) : For further details, please refer to the following page(s)
(Unless otherwise stated the results shown in this test report refer only to
the sample(s) tested)
Signed for
SGS-CSTC Standards Technical
Services Co., Ltd. Guangzhou Branch
Testing Center
Gary Bai
Authorized signatory
Summary of Results:
No. | Test Item | Test Method | Result | Conclusion |
---|---|---|---|---|
1 | Drop Test | With reference to MIL-STD-810H:2019 |
Method 516.8 Section 4.6.5 (Procedure
IV) and client’s requirement| No visual
damage| Pass
Note: Pass : Meet the requirements; Fail : Does not meet the requirements; / :
Not Apply to the judgment.
Test Sample Description:
Report Sample No. Lab Sample No. Description A 001 Plastic product
Original Sample Photo:
Test Item: Drop Test
Test Method: With reference to MIL-STD-810H:2019 Method 516.8 Section 4.6.5
(Procedure IV) and client’s requirement Test Condition: Drop Height: 122cm
Drop Plane: Wood plate Drop Times: Drop on each face, total 6 drops Lab
Environment Condition: 15C-35
C, 25%RH-75%RH Test Result:
Test Photo:
Sample | Results | Client’s requirement | Conclusion |
---|---|---|---|
1 | No visual damage | No visual damage | Pass |
Equipment Information:
Equipment | Model | Equipment No. | Calibration date | Next Calibration date |
---|
Small goods
drop tester| GK-SJDLO2| GZMR-RL-E126| 2021-10-22| 2022-10-21
**” End of report****
Unless otherwise agreed in writing, this document is issued by the Company
subject to its General Conditions of Service printed overleaf, available on
request or accessible at http://www.sgs.comien/Terms-and-Conditions.aspx
and, for electronic format documents, subject to Terms and Conditions for
Electronic Documents at http://www.sos.comien/Terms-and-
Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of
liability, indemnification and jurisdiction issues defined therein. Any holder
of this document is advised that information contained hereon reflects the
Company’s findings at the time of its intervention only and within the limits
of Client’s instructions, if any, The Company’s sole responsibility is to its
Client and this document does not exonerate parties to a transaction from
exercising all their rights and obligations under the transaction documents.
This document cannot be reproduced except in full, without prior written
approval of the Company. Any unauthorized alteration, forgery or falsification
of the content or appearance of this document is unlawful and offenders may be
prosecuted to the fullest extent of the law. Unless otherwise stated the
results shown in this test report refer only to tne sample(s) tested and such
sample(s) are retained for 30 clays only.
Attention: To check the authenticity of testing /inspection report &
certificate, please contact us at telephone: (86-755)83071443, or email:
Ckl.Docchecksgs cam SOS-CS .46-giciir01-,es Co itd. 198Keztt Rced, &Wet Pak
&Engem Evornic&Telnotgy DeRbFeriCistit, Guanyko, Chita 510663 t (86-20)
82155555 f (86-20) 82075188 www.sgsgroup.com. en
,;.;3-r”.t 217:r, & RFV, 510663 t (86-20) 82155555 f (86-20) 82075188 e
sgs.china@sgs.com
Member of the SGS Group (SGS SA)