MONACOR ESP-360 PA Wall Speaker Instruction Manual

June 5, 2024
MONACOR

MONACOR ESP-360 PA Wall Speaker Instruction Manual

Applications

This PA speaker for wall mounting is specially designed for PA systems using 100V technology. The power (3W or 6W) is matched via selection of the terminals.

Important Notes

The speaker corresponds to all relevant directives of the EU and is therefore marked with CE.
The speaker corresponds to the relevant UK legislation and is therefore marked with UKCA

  • The speaker is suitable for indoor use only. Protect it against dripping water and splash water, high air humidity and heat (admissible ambient temperature range 0–40°C).
  • For cleaning only use a dry, soft cloth; never use chemicals or water.
  • No guarantee claims for the speaker and no liability for any resulting personal damage or material damage will be accepted if the speaker is used for other purposes than originally intended, if it is not connected in an expert way or if it is overloaded.

If the speaker is to be put out of operation definitively, dispose of the speaker in accordance with local regulations.

Installation

WARNING During operation, there is a hazard of contact with a dangerous voltage of up to 100V at the speaker cable. Installation must be made by skilled personnel only. Observe the load of the PA amplifier by the speakers. Overload may damage the amplifier! The total load of all speakers connected must not exceed the amplifier power.

  1. Before installing the speaker, switch off the PA amplifier so that the speaker cable will not carry any voltage!
  2. Connect the speaker via two of the rear terminals to the 100V audio cable of the PA amplifier: Use the black terminal “COM” (negative pole) and, according to the desired power rating, either the red terminal “3W” or the white terminal “6W”. When connecting several speakers, make sure that all speakers have the same polarity and that the PA amplifier is not overloaded.
  3. Safely install the speaker on the wall using the drill hole below the terminals.

Specifications

  • Frequency range : 130–15000Hz
  • Power rating : 3W or 6W
  • Dimensions: 185 × 255 × 123mm
  • Weight: 1.1kg

Subject to technical modification.

Copyright© by MONACOR INTERNATIONAL
All rights reserved
A-0550.99.03.05.2022

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals