UMIDIGI B08LL3LJV5 Smart Watch Instruction Manual

B08LL3LJV5 Smart Watch
**Instruction Manual

**

Operating Instructions
Please read the instructions carefully and keep them safe.

Bind Watch

1. Download and install the App
You can set up the watch through the Da Fit app for iOS or Android devices. The steps are shown as follows:
Notes: The hardware platform of the equipment system shall meet requirements.

Bind process

Turn on the Bluetooth on your mobile phone Find the binding request on the pull-down list on the home page of the APP| Select product model: Uwatch 2S| Find the Bluetooth address complete binding.

Note: During the binding process, Da Fit will prompt you to enable GPS and Bluetooth, and authorize Da Fit to access GPS on your phone. After binding the Apple phone, you need to pair the Uwatch 2S watch with the phone’s Bluetooth so that the watch can provide various information.

Synchronous Data

The data is synchronized in real-time, and the sports mode can save a piece of sports information shown as follows:

Instruction for Use

1. Charging schematic
Connect and charge the watch according to the picture. It needs to be charged to activate the watch when it is started for the first time.
2. Wear/Install Wear

Wear the device a finger’s distance from the wrist bone and adjust the tightness of the wristband to a comfortable position.| Flip the switch and take out the wristband.

Tip: Wearing too loosely may affect the accuracy of heart rate data.

Operating Instructions

HOME key function

HOME, long press for three seconds to display the model/version number/Bluetooth address, and then long press for three seconds to display shutdown/ factory reset/cancel, Normal shutdown, press and hold for three seconds to boot.
Return to the previous menu function
2. Dial function
Press and hold the dial for 3 seconds to display the model/version number/ Bluetooth address, Press and hold again to enter Shutdown/ Restart/ Cancel
3. Main interface operation
Swipe the screen to enter different interfaces (interactive interface tile diagram)

Function Introduction

1. Icon function introduction

Enter the sports menu, you can choose different sports mode| Perform a heart rate test to check your heart rate data for the day.| Suitable for measuring blood oxygen levels
Suitable for measuring diastolic/systolic blood pressure measurements are for reference only| After connecting the device can remote contral the camera on your phone| Replacement and custom dial
Control music playing on your mobile phone (the watch cannot store music)| With timing function.| Turn on the find phone ring tone prompt.

Notes: For more functions (sleeping) and operation, please check the Da Fit software of the mobile phone.
2. Start sports

1. Enter sports
   Click the sports icon select the sports type > and enter the sports countdown automatically

2. During sports
   Pause motion: Swipe right to stop and resume Recovery Exercise: Click to resume exercise

3. Stop exercise:
   Remind whether to end this exercise Select Yes

3. Heart rate test

Note: Please wear the strap tightly to test accurately when testing heart rate.

Product Parameters

Cleaning and Maintenance

It is recommended to wear and maintain according to the following three points:

1. Keep the product clean;
2. Keep the product dry;
3. Do not wear it too tight.

Do not use household cleaners to clean the watch, but use the soap-free detergent.
It is recommended to use alcohol to scrub stains that are not easy to remove.

Frequently Asked Questions

1. The Mobile APP search for the watch failed
   1  It is recommended to restart Bluetooth after restarting the phone, and then connect.
   2  Confirm whether the mobile phone system meets Android 4.4 or IOS 8.0 or above.

2. The watch received no alerts, text messages or phone calls
   1  You need to turn on the smart reminder function and the call reminder switch in the APP, and synchronize to the watch.
   2  The iphone needs to be paired with the watch via Bluetooth. (Please check the column of “Synchronous Data” for details)
   3  You need to keep your watch connected to Bluetooth.

3. Bluetooth is often disconnected
   1  If the distance between the watch and the mobile phone is too far, the connection effect of more than 10m Bluetooth is obviously weakened.
   2  Whether there is a shield between the watch and the mobile phone, the human body, wearing metal jewelry, etc., will interfere with the Bluetooth connection signal.
   3  Whether the Bluetooth function of the mobile phone is abnormal.

4. About data backup
   The data of the watch is synchronized at least once every 3 days to the mobile phone (the watch end only keeps the data of the last 3 days).|

5. How to restart: long press the dial once> version information> long press again> shutdown/restart/cancel> click restart\

6. Do I need to keep my Bluetooth on when I wear my watch?
   1  You only need to wear a watch when you exercise, you can connect the watch and your mobile phone to view the data synchronously after the exercise.
   2  For the functions of call alert, message alert, find the phone, you need to turn on the mobile phone’s Bluetooth, and maintain the connection with the mobile phone.

Safety and Product Information Notes

Warning
Battery warning
Do not disassemble, bore or damage the battery. Do not disassemble the built- in batteries of non-replaceable battery devices. Do not use sharp objects to remove the battery.
Health Warning
If you are wearing a pacemaker or other implanted electronic devices, please consult your doctor before using the heart rate monitoring strap. The optical heart rate sensor of the watch glows green and blinks. If you have epilepsy or are sensitive to flashing light sources, please consult your doctor if you can wear this product. The device tracks your daily activities through sensors. These data are intended to tell you about your daily activities, such as steps, sleep, distance, heart rate and calories, but may not be completely accurate. The device, accessories, heart rate sensors and other relevant data are designed for entertainment and fitness, not for medical purposes. They are not applicable to the diagnosis, monitoring, treatment or prevention of any diseases or symptoms. The heart rate data is for reference only. We are not responsible for any consequences caused by any data deviation.
Cycling Warning
Please maintain good judgment at all times and ride in a safe manner. Make sure your bike and hardware are properly maintained, and all components are properly installed.

**Matters Needing Attention

**

• Watch data needs to be kept once every 3 days to avoid data loss.
• The watch has no waterproof effect on seawater, acidic and alkaline solutions, chemical reagents and other corrosive liquid.
• The damage or defects caused by misuse or improper use are not covered by the warranty.
• Sports mode supports up to 6 hours of exercise at a time. Avoid wearing the watch too tight in daily use.
• Please keep the parts of the watch touching the skin dry.
• When your heart rate is measured, keep your arm still during the test.

The device meets the EU ROHS criterion.
Please refer to IEC 62321, EU ROHS
Directive 2011/65/EU and revised directive.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

CAUTION
RISK OF EXPLOSI ON IFBATTERY IS REPLA CEDBYAN INCORRECT ECTTYPE DISPOSE OF USED BATTERI ESA CCORDING TO THE INSTRUCTIONS
Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycling valuable raw materials and the treatment of toxic stances.

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>