Barthelme 66000774 Wireless RGB-TW Controller Instruction Manual
- June 5, 2024
- Barthelme
Table of Contents
Barthelme 66000774 Wireless RGB-TW Controller
INTRODUCTION
Since this remote control is an accessory of the 66000770 control unit, it can
only be used in conjunction with this control unit. The operating instructions
of the control unit must be observed.
The outputs of the control unit are controlled depending on the use of the
coupled remote control/touch panel. This remote control is a 5-channel device,
for RGBW/TW applications. Up to four zones can be controlled separately per
remote control.
Each control unit can be paired with up to eight different remote controls.
Within a network, all colors can be synchronized automatically. The range
depends strongly on the spatial conditions; in the open field up to 50 meters
are possible, in-doors a reliable operation over 20 to 30 meters is normally
possible without problems.
INTENDED USE
The remote control allows you to adjust colors or to select effects.
It uses a button and a touch-sensitive round slider.
The remote control uses a radio frequency that is license-free in the EU,
Switzerland, Norway and Iceland.
TECHNICAL DATA
- Operating voltage: 4.5 V DC
- Batteries: 3x 1.5 V (AAA batteries) Protection class: III
- Dimensions (L/W/H): 120 / 55 / 17 mm
- Ambient temperature: 0 °C to max. + 40 °C
- Relative air humidity: 8 % to 80 %
- Wireless frequency: 869.5 MHz (license-free in the EU, Switzerland, Norway and Iceland).
- Indoor range: 20 to 30 meters
- Protection class : IP 20
SAFETY INSTRUCTIONS
In case of improper operation, reverse polarity, modification of the device,
or damage to property or persons caused by improper handling or non-observance
of the safety instructions, we do not assu-me any liability and the warranty
claim expires completely.
The product may only be installed by a qualified specialist who is familiar
with the applicable regulations (e.g. DIN, VDE, EN).
OPERATION
Only operate the product when it is functioning properly. In the event of a fault, switch the product off immediately and do not operate it again until it has been checked by a qualified electrician. This is the case if:
- visible damage occurs
- the product does not work properly
- there is smoke, fumes, or audible crackling noises
- overheating can be detected
COMMISSIONING
Connect the touch panel, install it in an installation box, switch it on
(status LED lights up blue) and pair it with the control unit..
ATTENTION! The product may only be installed by a qualified specialist
who is familiar with the applicable regulations (e.g. DIN, VDE, EN).
STEP 1: Press the „learn button“ on the RF recei-ver or turn on the receiver three times continuously to put it into the connection status
STEP 2: Touch the slider, the LED lights connected to the RF receiver will blink once, which means the receiver is successfully connected to the remote controller
FUNCTION
- RGB slider to select R/G/B color.
- Touching the two color slider, you can adjust the color temperature between warm white and cool white
- Press to turn on or off
- Press and hold to increase or decrease the light intensity of the RGB channels
- Press and hold to increase or decrease the light intensity of the Tunable White channels.
- Press to play or pause the ten built in effects, press and hold to speed up or slow down the effects
PRE-DEFINED RGB COLOR GRADIENTS
SCOPE OF DELIVERY AND ACCESSORIES
Each remote control is supplied with (the-se) instructions. It is part of the
scope of delivery for the device and must be handed over to the end user.
Important: All instructions for Barthelme products can be downloaded from
the Internet at www.barthelme.de. Please check for updates before use!
SIMPLIFIED EU DECLARATION OF CONFORMITY:
Barthelme hereby declares that wireless equipment type 66000774 is in compli-
ance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following Internet address:
www.barthelme.de/shared/download/CE_declaration_66000774.pdf
CONTACT
Josef Barthelme GmbH & Co. KG Oedenberger Str. 149
90491 Nürnberg | Germany
T: +49 911 42 476 0
E: info@barthelme.de
www.barthelme.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>