FALCON RIDGE KY-700-2018-TC01 2018 Kymco 700 Soft Top Cap Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
RIDGE KY-700-2018-TC01 2018 Kymco 700 Soft Top Cap
Instruction Manual
KY-700-2018-TC01 2018 Kymco 700 Soft Top Cap
Notice: Do not smoke inside the cab or expose the enclosure to direct
flames. The cab is Flammable.
Be sure to read these instructions thoroughly before opening and installing
the 2018 Kymco 700 Soft Top Cap. The installation is best done when the
temperature is 70 degrees F. or warmer. The temperature affects the adhesive
Velcro, if conditions prevent installing in warmer weather it helps to store
the adhesive Velcro at room temperature prior to installation.
- Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.
- Check over the parts included in the carton with the parts list shown below:
36″ Webbing Straps w/ Velcro| 4 each
---|---
36″ Webbing Straps w/ Loop| 4 each
36″ Webbing Straps w/ Grommet| 2 each
2” Adhesive Velcro Hook Strips:| 4 each 6” long
If any parts are damaged or missing please contact customer service at 606-845-7439.
-
If you have a Lexan windshield already installed on your Kymco you can do one of two things. You may use the straps with a Velcro sewn to one end and wrap the roll cage using the 6″ adhesive Velcro strip. Or if you have a Falcon Ridge windshield use the straps with a loop on one end and wrap it around the roll cage at the bottom of the windshield. If you choose you may also use the straps with grommet holes in one end. To use these just use one of the bolts on the windshield. Put the grommet through the bolt and reattach. The strap with the loop should look like the photo on the next page.
-
Next, take the other two straps with a loop sewn on one end and wrap them around the roll cage in the rear just under the safety bar.
-
Now place the top over the entire vehicle, the front of the top is identified by the sides not being as steeply curved, and begin by lacing the front straps through the ladder lock buckles sewn to the front corners of the top. The diagram below shows how to use a ladder buckle.
-
Now run those straps up and through the ladder lock buckles sewn to the rear of the top.
-
You now need to tighten and loosen the strap of the top so that it is centered correctly.
Cleaning and Storage Recommendations
-
Before removing the Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
-
It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory.
On a large, clean, and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter.
Put the rolled Cab back into the carton for storage at normal room temperature. It is best not to expose the Cab to either extremely hot or cold temperatures when storing. -
A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if the additional hook and loop sets are needed, they can also be ordered.
Thank you for your purchase!
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from the date item is received. You MUST package the product exactly
as it was originally packaged from the factory to get a full refund for the
product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes. Lay all the windows on top of each other with the canvas
folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory-new condition to receive a refund – a
25% restocking fee will apply.
If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors’, you must first call them and
see what their return policy is. Once your item reaches our production
facility, our customer satisfaction team will inspect your item to ensure
unused, factory-new condition. NOTE: All windshields must be returned with the
original protective film intact and not removed. Do NOT REMOVE it if you have
any intentions of returning the item. Refund/ replacement of a windshield will
only be processed on items with original protective film or if the windshield
is defective.
Items must be properly packaged in the original shipping carton to protect
them during transit and ensure your returned item arrives back factory fresh,
and in new resalable condition (any returned items that have been used,
altered, or damaged in any way will not be subject to a refund.) All contents
including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will
be approved. Once returned items are received, a credit will be issued to the
original credit card/ payment method used for the purchase. Outbound shipping
and return shipping costs will not be refunded. Please allow 4 to 6 weeks for
your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure,
tops, and/or windshield due to defects of the product. Please refer to the
return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this
time frame we will gladly correct the problem or replace the enclosure, tops
&/or windshield. Upon submitting for the correction or replacement we will
need to receive pictures of the defect in material or workmanship along with
the receipt from the date of purchase.