FALCON RIDGE CF-ZFORCE-SDK01 CF Moto Z Force Soft Door Kit Instruction Manual

CF-ZFORCE-SDK01 CF Moto Z Force Soft Door Kit
Instruction Manual

CF-ZFORCE-SDK01 CF Moto Z Force Soft Door Kit

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. The cab is Flammable.
Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to installation.

1. Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.

2. Check over the parts included in the carton with the parts list shown below:
   Adhesive Velcro Hook Strips:
   “ “ “ “
   “ “ “ “
   Snap Screw Studs
   Soft Doors
   18 each————3″
   2 each————20″
   21 each (1 extra)
   If any parts are damaged or missing please contact customer service at 606-845-7439.

3. Begin by holding the door up to the frame and attaching it using the double-sided Velcro strips sewn perpendicular to the edge of the door. At each of the double-sided strips take one of the 3″ adhesive Velcro strips and adhere it to the inside of the frame. Then wrap the double-sided strip around it so that the adhesive strip holds it firmly in place. The following diagrams show how it should look.
   

4. Next, take the 20″ adhesive Velcro strips and run it down the back of the roll cage facing towards the rear of the vehicle. Start at the bottom and work your way up the bar.  You will see the double-sided Velcro tabs sewn along the back of the doors. See the photo below.
   

5. Once all the Velcro is in place the last thing to do is install the screw snap studs. NOTE: The best way to install the snap studs is to put them in the sockets in the door first.  Then push them into the plastic to make a mark. Then pull the screw stud out and screw it into the plastic where the mark was made. See the Photo on the next page.
   

Cleaning and Storage Recommendations:

1. Before removing the Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll it for storage.

2. It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory.
   On a large, clean, and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter.
   Put the rolled Cab back into the carton for storage at normal room temperature. It is best not to expose the Cab to either extremely hot or cold temperatures when storing.

3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if the additional hook and loop sets are needed, they can also be ordered.

Thank you for your purchase!

Documents / Resources

| FALCON RIDGE CF-ZFORCE-SDK01 CF Moto Z Force Soft Door Kit [pdf] Instruction Manual
CF-ZFORCE-SDK01, CF Moto Z Force Soft Door Kit, CF-ZFORCE-SDK01 CF Moto Z Force Soft Door Kit, Z Force Soft Door Kit, Soft Door Kit, Door Kit
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>