FALCON RIDGE PO-19RZR-WD02 2019 Polaris RZR Polycarbonate Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE PO-19RZR-WD02 2019 Polaris RZR Polycarbonate Windshield
INSTALLATION INSTRUCTION
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film. Once the film is removed you cannot return the product for a full refund.
- Be sure to read these instructions thoroughly before opening and installing the 2019 Polaris RZR Polycarbonate Windshield.
- Check over the parts included in the cartons with the parts list shown below:
- Strap Clamps 4 each
- 46” Side Bulb Gasket 1 each
- 1/2″ wide Adhesive Padding 36″ Long
- Windshield 1 each
- Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the protective film. Next take the 46” piece of rubber gasket and starting at one end firmly place across the bottom of the windshield. You may need to trim any excess.
- Next take the adhesive padding and place it around the plastic piece on the RZR at the top of the roll cage. You will see a space where the windshield will sit in. This is where to place the padding. See photo below.
- You are now ready to install the windshield on your roll cage. Place the windshield on the vehicle first. Then take the four Velcro clamps and place them through the square holes then wrap the strap around the roll cage and under the wire as shown in the photo below.
- Then just Pull the strap back around the bar and attach it to the Velcro.
- Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using microfiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Read User Manual Online (PDF format)
Loading......