M232-M237 series HP LaserJet MFP User Guide
- June 3, 2024
- HP
Table of Contents
**M232-M237 series HP LaserJet MFP User Guide
**
Control panel
Copy Options
Copy button/light
ID Card Copy button/light
Information button/light Press to print a summary of printer settings and
status.
Resume button/light Press when lit to continue a job.
Cancel button/light
Power button
Wireless button1
Status light2 Blinks when starting or processing a job.
Paper light
Blinks when out of paper or paper is jammed.
Attention light2
Cartridge light
Blinks when cartridge needs attention.
Open Lid light
Open lid and turn over ID card to copy second side.
Wi-Fi Direct icon1
Status lights
Pulsing purple
Wireless setup mode. Lasts for 2 hours after first turning on printer. See
“Help and tips for Wi-Fi and connectivity”.
Pulsing blue
Connecting to network
Solid light blue
Connected/ready for use
Solid amber
Problem. Check the HP Smart app for troubleshooting information.
Pulsing green
Updating or busy
For more information on lights and errors, visit hp.com/support/ljM232MFP
Help and tips for Wi-Fi and connectivity
If the software is unable to find your printer during setup, check the following conditions to resolve the issue.
| Potential Issue | Solution |
|---|
Printer Wi-Fi setup mode timed out
| If the status light is not purple, the printer might not be in Wi-Fi setup
mode. Restart setup mode: 1. If the control panel is not lit, press to exit
sleep mode. 2. Press and hold for 5 seconds and then release the button. All
control panel buttons will light up. 3. Press and at the same time once and
then release the buttons. The status light will purple. 4. Wait for one
minute. Close and reopen HP Smart, and then try connecting again.
Computer or mobile device too far from printer| Move your computer or mobile
device closer to the printer. Your device might be out of range of the
printer’s Wi-Fi signal.
Computer connected to a Virtual Private Network (VPN) or remote work network|
Disconnect from a VPN before installing HP Smart software. You can’t install
apps from the Microsoft Store when connected to a VPN. Connect to the VPN
again after finishing printer setup. Note: Consider your location and the
security of the Wi-Fi network before disconnecting from a VPN.
Wi-Fi turned off on computer (computer connected by Ethernet)| If your
computer is connected by Ethernet, turn on the computer’s Wi-Fi while setting
up the printer. Disconnect the Ethernet cable temporarily to complete setup
over Wi-Fi
Bluetooth and location services are turned off on your mobile device| If
setting up with a mobile device, turn on Bluetooth and location services. This
helps the software find your network and printer. Note: Your location is not
being determined and no location information is being sent to HP as part of
the setup process.
Help and Support
For printer troubleshooting and videos, visit the HP support site. Enter your model name to find the printer.
https://www.hp.com/support/ljM232MFP
© Copyright 2021 HP Development Company, L.P.
Microsoft and Windows are either registered trademarks or trademarks of
Microsoft Corporation in the United Stated and/ or other countries. Mac, OS X,
macOS, and AirPrint are trademarks of Apple Inc., registered in the U.S. and
other countries.
Android is a trademarks of Google LLC. iOS is a trademark or registered
trademark of Cisco in the U.S. and other countries and is used under license.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>