FALCON RIDGE HO-700-WD05 Honda Pioneer 700 Aero-Vent Front Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE HO-700-WD05 Honda Pioneer 700 Aero-Vent Front Windshield
INSTALLATION INSTRUCTION
NOTICE: Please check contents of package for any damage and make sure all
parts fit correctly and you are happy with the product before removing
protective film. Once the film is removed you cannot return the product for a
full refund.
Be sure to read these instructions thoroughly before opening and installing
the John Honda Pioneer 700 and 700/4 Aero-Vent Polycarbonate Windshield.
-
Check over the parts included in the cartons with the parts list shown below:
- 1 5/8” Loom Clamps 8 each
- 1” Stainless Steels Bolts 13 each
- Stainless Steel Washers 17 each
- Plastic Thumb Nuts 9 each
- Lock Nuts 4 each
- Slide Fasteners 4 each
- 52” Rubber Gasket 1 each
- Polycarbonate Brace 1 each
- Polycarbonate Vent Slider 1 each
- Polycarbonate Windshield 1 each
If any parts are damaged or missing please contact customer service at 606-845-7439.
-
Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the protective film. Next take the 52” piece of rubber gasket and starting at one end firmly place across the bottom of the windshield. You may need to trim off excess gasket. The diagram below show where to install the gasket. Diagram Not Pioneer 700.
-
Next install the sliding vent panel on the inside of the windshield as shown in the diagram below. To install slide fasteners push through holes with thumbs until it is completely through the hole in the windshield and locked in place.
-
Now the Windshield is ready to be installed. With the help of a friend, place the Windshield on the Pioneer, setting it up onto the hood.
-
Take the remaining hardware and install the windshield to the roll cage as shown in the diagram on the next page.
-
Now you can install the top brace if you want. If you do not have an Ape Offroad Cab enclosure to work with this windshield, the top brace is not needed but can be installed for extra strength. Below is a diagram showing how the brace is to be installed.
-
If you are using this windshield with an Ape Offroad Cab enclosure then you will use the Top Brace to sandwich the cab material and seal off the inside from the wind. The diagram below shows how it will work. If you aren’t using one of Ape Offroad’s Cab Enclosure you may opt not to use the Top Brace or install it for added strength.
-
Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using microfiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from the date the item is received. You MUST package the product
exactly as it was originally packaged from the factory to get a full refund
for the product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes. Lay all the windows on top of each other with the canvas
folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory-new condition to receive a refund – a
25% restocking fee will apply. If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors, you must first call them and see
what their return policy is. Once your item reaches our production facility,
our customer satisfaction team will inspect your item to ensure unused,
factory-new condition. NOTE: All windshields must be returned with the
original protective film intact and not removed. Do NOT REMOVE if you have any
intentions of returning the item. Refund/ replacement of a windshield will
only be processed on items with original protective film or if the windshield
is defective.
Items must be properly packaged in the original shipping carton to protect
them during transit and ensure your returned item arrives back factory fresh,
and in new resalable condition (any returned items that have been used,
altered or damaged in any way will not be subject for a refund.) All contents
including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will
be approved. Once returned items are received, credit will be issued to the
original credit card/ payment method used for the purchase. Outbound shipping
and return shipping cost will not be refunded. Please allow 4 to 6 weeks for
your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty. 30 Day Warranty which includes and is not limited to
replacing the enclosure, tops and/or windshield due to defects of the product.
Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this
time frame we will gladly correct the problem or replace the enclosure, tops
&/or windshield. Upon submitting for the correction or replacement we will
need to receive pictures of the defect in material or workmanship along with
the receipt from the date of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>