FALCON RIDGE AC-TRAIL-DRW01 Textron Wildcat Trail Soft Doors & Rear Window Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE AC-TRAIL-DRW01 Textron Wildcat Trail Soft Doors & Rear
Window
Instructions for Installation and Care of Arctic Cat / Textron Wildcat Trail / Sport Soft Door Rear Window Comb
AC-TRAIL-DRW01 AC-SPORT-DRW01
Notice : Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
INSTALLATION INSTRUCTIONS
Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to installation.
-
Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.
-
Check over the parts included in the carton with the parts list shown below
Adhesive Velcro Hook Strips: Soft Doors -
“ “ “ “ 24 each————3″
-
“ “ “ “ 2 each————-6″
-
“ “ “ “ 2 each————44”
Adhesive Velcro Hook Strips: Rear Window -
“ “ “ “ 6 each————3″
-
“ “ “ “ 2 each————18”
-
“ “ “ “ 1 each————44”
If any parts are damaged or missing please contact customer service at 606-845-7439
Soft Doors
-
Begin by holding the door up to the frame and attach it using the double-sided Velcro strips sewn perpendicular to the edge of the door. At each of the double-sided strips take one of the 3″ adhesive Velcro strips and adhere it to the inside of the frame. Then wrap the double-sided strip around it so that the adhesive strip holds it firmly in place. The following diagrams show how it should look.
-
Next take the 10″ and a 3” adhesive Velcro strips and run it down the back of the roll cage facing towards the rear of the vehicle. They should match up with the double-sided Velcro tabs sewn along the rear of the soft door. See photo below
-
Next take the 6” adhesive Velcro strip and place it on the front fender as shown in the photo below. Then affix the bottom of the front panel to it as shown in the second photo.
-
Last part of the door to attach is the bottom to the factory half-door. Take the 44” adhesive Velcro strip and attach it to the factory door to match up with the Velcro sewn to the bottom of the soft doors. The adhesive Velcro will cross the hinge of the door, take a knife and cut the adhesive Velcro at the hinge.
REAR WINDOW -
Now install the rear window. The top of the Rear window is held in place by double-sided strips like the ones on the doors.
-
The sides will attach to the double-sided tabs from the rear of the doors. The bottom will attach to the vehicle using the 42” adhesive Velcro strip as shown in the following photos.
Cleaning and Storage Recommendations:
- Before removing the Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered
Thank you for your purchase!
Return Policy
If for any reason you choose to return this product it must be returned within 30 days from date item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product! The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows. All returned products will be inspected upon arrival at the production facility and must be in unused, factory new condition to receive refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is.
Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.
NOTE : All windshields must be returned with the original protective film
intact and not removed. Do NOT REMOVE if you have any intentions of returning
the item. Refund/ replacement of a windshield will only be processed on items
with original protective film or if the windshield is defective.
Items must be properly packaged in the original shipping carton to protect
them during transit and ensure your returned item arrives back factory fresh,
and in new resalable condition (any returned items that have been used,
altered or damaged in any way will not be subject for a refund.) All contents
including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will
be approved. Once returned items are received, credit will be issued to the
original credit card/ payment method used for the purchase. Outbound shipping
and return shipping cost will not be refunded. Please allow 4 to 6 weeks for
your refund to be processed.
Warranty
To The Owner of this Product: Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product. Please refer to the return policy in this case for more information. 1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>