SONOS Beam Wall Mount Soundbar User Guide
- June 6, 2024
- Sonos
Table of Contents
SONOS Beam Wall Mount Soundbar
Connect the optical adapter to the TV’s optical digital OUT port.
Note: The optical adapter’s port is “D-shaped”—make sure the connector aligns correctly into the port. Inserting the adapter incorrectly may damage the cable. If you don’t have the app, download it from the app store. You’ll use it to set up and control your Sonos system. See Getting started.
The microphone on/off
Touch to turn the microphone on and off. (If you don’t have a voice service installed, the microphone is inactive.) When the microphone light is on, voice control is on and your voice assistant is ready to respond. When the microphone light is off, voice control is off. Note: If you’ve installed a voice service and the microphone is off, you can still use voice commands. Just press and hold —no need to start with a wake word. When you release the microphone button, voice control turns off again.
Wall mount
Guidelines
- Use the Beam wall mount kit. You can buy it on www.sonos.com. Follow the instructions in the kit.
- Keep 1″ (25mm) space (minimum) above Beam so you can reach the touch controls.
- If you’re mounting above the TV, make sure you can reach the touch controls.
- For best sound quality, keep both ends of Beam at least 1′ (30cm) from a wall or other obstruction.
Mount kit contents
- Wall mount bracket
- 4 wall anchors
- 4 wall screws
- 2 screws
Note: Don’t discard the template. It may look like packing
material.
- Tape the cardboard template to the wall above or below your TV. Use a level. Keep 1″ (25mm) space (minimum) for access to Beam’s touch controls. (Don’t install Beam vertically.)
- Mark the center of the mounting holes and remove the template.
- Use a 5/16″ drill bit to drill pilot holes (see Wall mounting information)
- Insert and secure the wall anchors (don’t use the anchors if drilling into the wood).
- Place the bracket on the wall and loosely tighten the wall screws to secure the bracket. Check with a level and then tighten the screws.
- Connect the power and HDMI cables to Beam.
- Place Beam on the bracket.
- Insert and tighten Beam to the bracket using the mounting screws.
Wall mounting information
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>