JD-550-TC01 John Deere Gator 825m Falcon Ridge Soft Top Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
John Deere Gator 825m Falcon Ridge Soft Top
Instruction Manual
JD-550-TC01 John Deere Gator 825m Falcon Ridge Soft Top
Instructions for Installation and Care of John Deere XUV 550 Top Cap Canopy
JD-550-TC01
CAUTION: Do not smoke inside the cab or expose the enclosure to direct
flames. The product is FLAMMABLE.
Be sure to read these instructions thoroughly before opening and installing.
The installation is best done when the temperature is 70 degrees F. or warmer.
The temperature affects the adhesive Velcro, if conditions prevent
installation in warmer weather it helps to store the adhesive Velcro at room
temperature prior to installation.
-
Open the carton and remove the rolled up Top Cap on a large flat surface that is clean and free of dirt.
-
Check over the parts included in the carton with the parts list shown below:
Velcro Hook strips: ———————————————— 4 each 6” long
Double-Sided Velcro w/ 30” Straps Attached —————— 4 each
30” Straps with grommets —————————————– 2 each
Top Panel ———————————————————— 1 each
If any parts are damaged or missing please contact customer service at606-845-7439. -
If you have a Lexan windshield already installed on your John Deere you can do one of two things. You may use the straps with Velcro sewn to one end and wrap the roll cage under the windshield with the 6” adhesive Velcro strips. Then wrap the double-sided Velcro sewn to the end of the strap around the adhesive Velcro. If you choose you may also drill a 5/16” hole in the windshield and bolt the strap with the grommet directly to the windshield. The bolt should be installed from the inside out with a washer then strap, another washer, and a locknut. Tighten all the way down and then loosen the locknut ½ a turn to free the strap to allow it to swing around to any position.
-
Now place the top over the entire vehicle, the front of the top is identified by the sides not being as steeply curved, and begin be lacing the front straps through the ladder lock buckles sewn to the front corners of the top.
-
Now take two of the straps that are sewn to the double-sided Velcro and wrap then around the rear bar of the roll cage halfway between the bottom and the first bend up the bar. The strap should be on the outside of the bars.
-
Now run those straps up and through the ladder lock buckles sewn to the rear of the top.
-
You now need to tighten and loosen the strap of the top so that it is centered correctly and should cover the holes across the top of the windshield.
-
If you were installing the Top by itself you would use the two remaining straps with double-sided Velcro to attach the front. You may need to cut the straps once fitted, do not cut off too much as you have nothing to hold on to and pull it tight the next time you go to install it. It is recommended to leave about 6-8” hanging from the buckles.
Thank you for your purchase!
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from the date the item is received. You MUST package the product
exactly as it was originally packaged from the factory to get a full refund
for the product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes. Lay all the windows on top of each other with the canvas
folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory-new condition to receive refund – a
25% restocking fee will apply. If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors, you must first call them and see
what their return policy is. Once your item reaches our production facility,
our customer satisfaction team will inspect your item to ensure unused,
factory-new condition.
NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/ replacement of a windshield will only be processed on items with original protective film or if the windshield is defective. Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered or damaged in any way will not be subject for a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product: Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops, and/or windshield due to defects of the product. Please refer to the return policy in this case for more information. 1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>