FALCON RIDGE Full Polycarbonate Rear Window Instruction Manual

June 3, 2024
FALCON RIDGE

2515 Bypass Rd. Flemingsburg, KY 41041606-845-7439
Instructions for Installation and Care of
Full Polycarbonate Rear Window
PO-14FULLRANGER-RW02
Instruction Manual

Full Polycarbonate Rear Window

  1. Check over the parts included in the cartons with the parts list shown below:
    2 1/4″ Stainless Bolts| 8 each
    ---|---
    1 3/4″ Stainless Bolts| 6 each
    Nylon Spacers| 22 each
    Small Washers| 14 each
    Lock Nuts| 14 each
    Large Polycarbonate Pieces| 7 each
    Small Polycarbonate Pieces| 7 each
    145″ Small Side Bulb Gasket| 1 each
    Rear Window| 1 each

If any parts are damaged or missing, please contact customer service at 606-845-7439.

  1. Start by pulling it out of the box; find a clean area to lay it down and install the hardware. Next, take the rubber gasket and starting at one end firmly place it along the entire outer edge of the rear window. You will need to peel back the protective film from the edge to install the gasket. If you leave the bulk of the protective film on while installing you can avoid scratching the windshield. Ensure that the gasket is seated fully home along the edge to ensure a good fit of the windshield.
  2. Begin attaching the two bottom brackets before you put the window on the Ranger. These brackets are made up of several different parts that must be put together first. Below is a picture of the parts needed to make the bracket.FALCON RIDGE Full Polycarbonate Rear Window - FIGURE 1
  3. Take the 2 1/4″ bolts and run them through the one large and one small polycarbonate pieces as shown in the photo below. Do this four times.FALCON RIDGE Full Polycarbonate Rear Window - FIGURE 2
  4. Then take the nylon spacers and put 2 of them on the bolts as shown in the photo below.FALCON RIDGE Full Polycarbonate Rear Window - FIGURE 3
  5. Now take the two plates and spacers and insert them into the holes along the bottom so that the plates are on the inside or the gasket side of the windshield. See the photo below.FALCON RIDGE Full Polycarbonate Rear Window - FIGURE 4
  6. Now secure them in place with a small washer and lock nut on the front side of the Rear Window as shown in the photo belowFALCON RIDGE Full Polycarbonate Rear Window - FIGURE 5
  7. Now that the gasket and bottom brackets are in place it’s time to place the Rear Window in place on the vehicle. The brackets are designed to hold the window in place along the bottom of the frame behind the seats as shown in the photo below.FALCON RIDGE Full Polycarbonate Rear Window - FIGURE 6
  8. Once the Rear Window is in place and properly centered on the vehicle the final step is to install the brackets across the top of the window to secure it in place. This is done the same as the bottom brackets except you use just one spacer per bolt instead of two. See photo belowFALCON RIDGE Full Polycarbonate Rear Window - FIGURE 7
  9. Enjoy, and remember- when cleaning the rear window do so gently at first with warm water and mild detergent to dislodge any grit that may scratch the Polycarbonate. After rinsing and drying with a soft cloth, you may then polish the windshield with an appropriate commercially available plastic polish, also available from Falcon Ridge. This will ensure many seasons of clarity and keep scratching and swirling to a minimum. Never use cleaners such as Windex that contain ammonia as doing so may adversely affect the rear window.

Thank you for your purchase!

Return Policy

If for any reason you choose to return this product it must be returned within 30 days from the date item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund – a 25% restocking fee will apply.
If ordered from Falcon Ridge please call 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition.
NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE it if you have any intentions of returning the item. Refund/ replacement of a windshield will only be processed on items with original protective film or if the windshield is defective.
Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered, or damaged in any way will not be subject to a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, a credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping costs will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge’s Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure, tops, and/or windshield due to defects in the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

FALCON RIDGE User Manuals

Related Manuals