camry CR 7435 Electric Underlay Blanket User Manual
- June 5, 2024
- camry
Table of Contents
CR 7435 & CR 7436
User Manual
- ReaAWe instruction.
- Do not use folded or corrugated
- Do not knock out pins, needles, or other objects.
- Do not use it for very small children (0-3 years).
- Maximum %toasting temperature 30 ºC. Normal process.
The product may be used only with the control switch specified in the
equipment marking:
RA-1/T13
PLEASE READ CAREFULLY. IMPORTANT INSTRUCTIONS, KEEP FOR LATER USE.
-
Read the operating manual before using the device and follow the instructions contained in it. The manufacturer is not liable for damage caused by using the device against its intended use or improper handling.
-
The device is for domestic use only. Do not use it for other purposes that are not in accordance with its intended use.
-
Connect the device only to a 230 V ~ 50/60 Hz earthed socket. In order to increase the safety of use, do not switch on many electrical devices simultaneously to one circuit.
-
Be extra cautious when using the device when children are nearby. Do not allow children to play with the device, do not let children or persons not familiar with the device use it. The equipment should not be used by young children unless the controllers have been pre-set by parents or guardians, or children have been thoroughly instructed how to safely handle the regulators.
Children under three years of age cannot use this device due to the lack of response to overheating. -
WARNING: This equipment may be used by children over 8 years of age and persons with limited physical, sensory or mental abilities, or persons who have no experience or knowledge of the equipment, if this is done under the supervision of a person responsible for their safety or given to them. tips on the safe use of the device and are aware of the dangers associated with its use. Children should not play with the equipment. Cleaning and maintenance of the device should not be performed by children unless they are over 8 years of age and are supervised. This device cannot be used by people who do not heat sensitive, people who are very sensitive to heat, who are unable to respond to overheating, and by people who require constant care.
-
Always after use, remove the plug from the socket by holding the socket with your hand.
DO NOT pull on the power cord. -
Do not immerse the cable, plug, and the entire device in water or other liquid. Do not expose the device to atmospheric conditions (rain, sun, etc.) or do not use in conditions of high humidity (bathrooms, damp camping houses).
-
Periodically check the condition of the power cord. If the power cord is damaged, it should be replaced by a specialist repair facility in order to avoid a hazard.
-
Do not use the device with a damaged power cord or if the device is not working properly.
Do not repair the device yourself, as it may cause shock. Please return the defective device to the appropriate service center for inspection or repair. All repairs may only be carried out by authorized service points. The incorrectly performed repair can cause serious danger to the user. -
Do not use the device near flammable materials.
-
Do not leave the device or the adapter connected to the outlet unattended.
-
To provide additional protection, it is advisable to install a residual current device (RCD) with a rated residual current not exceeding 30 mm in the electrical circuit. In this regard, please contact an electrician.
-
Do not allow the device or adapter to get wet. If the device falls into the water, immediately pull the plug or adapter from the power socket. Do not put your hands into the water when the device is connected to the mains. Before re-use, it must be checked by a qualified electrician.
-
Do not handle the device or adapter with wet hands.
-
The device should be turned off every time you put it down.
-
Do not use the device near water, for example: in the shower, in the bathtub, or above the basin with water.
-
If the device uses a power supply, do not cover it, as it could lead to a dangerous increase in temperature and damage to the device. Always, first, insert the plug into the power socket in the device and then the power supply to the mains socket.
-
Do not use the bed sheet in folded condition. Do not put pins, needles, and other metal objects on the sheet.
-
Do not use the sheet if it is wet or damp. Leave the sheet hung loosely in a ventilated area until it is completely dry.
-
Do not put the power cord on a warmed sheet. Do not fold the equipment when it is placed on top during storage. Check the equipment periodically for signs of wear or damage.
If such signs or equipment are used improperly, please contact your supplier before continuing to use it. -
Store in a dry place. Never put heavy objects on the sheet.
-
Never go to sleep with the electric sheet turned on. Unplug the power plug from the outlet.
-
Never cover the controller.
-
Before switching on the electric sheet, make sure that it is evenly distributed, and that there are no kinks or folds.
-
The product can be washed in the washing machine at 30°C temperature. Disconnect the power cord and controller before washing. Switch or controller – the regulator must not be wet during washing, and during drying the cord must be in a horizontal position to ensure that the water does not flow into the switch or controller – regulator.
-
Do not iron the electric sheet!
-
This equipment is not intended for medical use in hospitals.
-
The device should cool down before storage.
-
The device may be used only with the types of removable elements specified in the equipment marking.
-
Do not use the device on adjustable beds or if the device is used on an adjustable bed, check that the blanket and cord cannot get stuck or corrugated, eg on hinges.
-
The device is equipped with a fuse protecting against overheating, which should not work when used in accordance with the intended use of the equipment. If the fuse trips, the device will stop working, and the equipment must be returned to the manufacturer or its representative for repair.
Product: Electric blanket underlay CR7435 / CR7436
BEFORE FIRST USE
- The product needs to be unfolded and laid flat before switching on.
- Fix the product according to the instructions in the chapter: Fitting your product on the bed.
- We recommend that you switch your product to the maximum setting for two to three hours before bedtime then reduce it to your desired heat setting 15 minutes before getting into bed. You must switch OFF prior to sleeping.
Fitting your product on the bed
- Place the product onto the mattress with the controller (or two) at the HEAD END but towards the foot end of the bed.
- The control switches should be below the normal head’s sleeping position.
- Unroll the tie tapes and pass the tapes under the bed as shown in the diagrams (Fig.1-6).
- Ensure the heating wires do not extend under pillows or hang over the sides. Pass the middle tie tape under the mattress and through the middle loop on the opposite side (Fig.1). Pass the end of the tape under the corresponding bottom corner of the mattress (Fig. 2) up through the center loop of the product (Fig. 3) and down under the opposite corner of the mattress and then through the side loop on the opposite side of the product (Fig 4).
- Repeat this process at the other end (Fig. 5).
DESCRIPTION OF THE DEVICE – electronic controller
1. Temperature controller
2. Power cord
3. Bed sheet/blanket/mat
4. Socket to disconnect the power cord before washing
5. Controller display| 6. Switch “ON/OFF
7. Heating setting indicator
8. Time setting indicator
9. Temperature setting button
10. Time & continuous operation setting button
11. Continuous operation indicator “Always on”
---|---
OPERATING INSTRUCTIONS – electronic controller
With daily use, the product will require 15 minutes of preheating before
bedtime.
You can program your product to work for 1, 2, or 10 hours of continuous
operation mode as well as fix temperature by choosing 1-8 heat settings.
- Plug product into the mains power supply.
- Switch on the product with a button (6). The product will come at a default setting of 8 heat and an operation time of 10 hours. The LED for timer (8) and temperature (7) will be illuminated.
- By pressing the Heat button (9) you will be able to adjust the temperature of heat settings in the range 1-8. Level 1 is the lowest heating and level 8 is the highest heating. This will be indicated with the LED.
- By pressing the Timer button (10) you will be able to adjust the time to turn the product off after a predetermined time is 1, 2, or 10 hours or fix the continuous operation mode. This will be indicated with the right LED light.
- In order to use the product in continuous mode before you fall asleep, press the Timer button (10) to select the continuous mode “Always on”. This will be indicated by the left LED light.
- Switch on the product and unplug it after use.
STORING
Always allow the product to cool down before folding and storing. Your product can remain on the bed all year round as a comfortable under the blanket. Simply remove the controls and store them until Winter. If you wish to remove the product from your bed when not in use, roll or fold it loosely and store it in a bag. Avoid creating sharp creases in the product; for example, do not store it under other items that may result in bending the inside heating wires.
CLEANING & AIR DRYING
The product can be machine washed because it is equipped with detachable
controllers.
Unplug and remove one or two power cords with controllers from socket (4) to
disconnect the power cord before washing.
Fold and presoak the product for 15 minutes in mild soap and lukewarm water
solution. Ensure the water temperature is less than 30°C.
- Wash on the delicate or gentle cycle for 2 minutes.
- Rinse in fresh lukewarm water.
- Gently stretch the product to its original size.
- Air dry over a clothesline. DO NOT use clothes pegs or clips of any kind.
- DO NOT use the product until it is completely dry!
- DO NOT iron the product !
TECHNICAL DATA
Nominated power input:
Supply voltage:
Dimensions:| CR7435 / CR7436
60W / 2 X 60W
230 V ~50/60Hz
150×80 / 150×160
---|---
To protect your environment: please separate carton boxes and plastic bags and
dispose of them in corresponding waste bins.
The used appliance should be delivered to the dedicated collecting points due
to hazardous components, which may affect the environment. Do not dispose of
this appliance in the common waste bin.
Turntable with radio
CR 1111| Waffle maker
CR 3022| Blender
AD 4070| Electric Kettle
CR 1242
Steam Cleaner
CR 5020| Automatic milk frother
CR 4464| Portable cooler
CR 8065| Easy Air Cooler
CR 7318
Foldable Electric Kettle
CR 1265| Air Cooler
CR 7908| WINE COOLER
CR 8068| Radio
CR 1153
Cube Radio with Bluetooth
CR 1165| Ceramic Heater
CR 7718| Super soft heating blanket
CR 7418| Electric Kettle
CR 1278
Velocity Fan
CR 7306| Air Cooler
CR 7905| Waffle maker
CR 3025| Hair Clipper
CR 2821
Portable Cooler
CR 93| Lint remover
CR 9606| Blender
CR 4058| Electric Blanket
CR 7407
Travel Iron
CR 5024| Electric Kettle
CR 1239| Food Slicer
CR 4702| Trimmer
CR 2921
Bluetooth Speaker
CR 1170| Kettle with temp. control
CR 1289| Hair styler set
CR 2024| Hair Dryer
CR 2255
AFTER-SALE SERVICE NOTICE
If you want to buy spare parts or make any complaints, please contact the
seller who issued the receipt directly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>