camry CR7423 Heated Under Blanket User Manual

: May 15, 2024
: camry

Table of Contents

Symbols
IMPORTANT INSTRUCTIONS
Product
Fitting your product on the bed
STORING
CLEANING & AIR DRYING
Other Model
TECHNICAL DATA
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

camry CR7423 Heated Under Blanket

camry CR7423 Heated Under Blanket

Symbols

Read the Instruction.
Do not use folded or corrugated.
Do not knock out pins, needles or other objects.
Do not use for very small children (0-3 years).
Maximum washing temperature 30 ° C. Normal process.

The product may be used only with the control switch specified in the equipment marking:

IMPORTANT INSTRUCTIONS

PLEASE READ CAREFULLY. IMPORTANT INSTRUCTIONS, KEEP FOR LATER USE.

Read the operating manual before using the device and follow the instructions contained in it. The manufacturer is not liable for damage caused by using the device against its intended use or improper handling.
The device is for domestic use only. Do not use for other purposes that are not in accordance with its intended use.
Connect the device only to a 230 V ~ 50/60 Hz earthed socket. In order to increase the safety of use, do not switch on many electrical devices simultaneously to one circuit.
Be extra cautious when using the device when children are nearby. Do not allow children to play with the device, do not let children or persons not familiar with the device use it. The equipment should not be used by young children, unless the controllers have been pre-set by parents or guardians, or children have been thoroughly instructed how to safely handle the regulators.
Children under three years of age cannot use this device due to the lack of response to overheating.
WARNING: This equipment may be used by children over 8 years of age and persons with limited physical, sensory or mental abilities, or persons who have no experience or knowledge of the equipment, if this is done under the supervision of a person responsible for their safety or given to them. tips on the safe use of the device and are aware of the dangers associated with its use. Children should not play with the equipment. Cleaning and maintenance of the device should not be performed by children unless they are over 8 years of age and are supervised. This device cannot be used by people who are not heat sensitive, and people who are very sensitive to heat, who are unable to respond to overheating and by people who require constant care.
Always after use, remove the plug from the socket by holding the socket with your hand. DO NOT pull on the power cord.
Do not immerse the cable, plug and the entire device in water or other liquid. Do not expose the device to atmospheric conditions (rain, sun, etc.) or do not use in conditions of high humidity (bathrooms, damp camping houses).
Periodically check the condition of the power cord. If the power cord is damaged, it should be replaced by a specialist repair facility in order to avoid a hazard.
Do not use the device with a damaged power cord or the device is not working properly.
Do not repair the device yourself, as it may cause shock. Please return the defective device to the appropriate service center for inspection or repair. All repairs may only be carried out by authorized service points. Incorrectly performed repair can cause serious danger to the user.
Do not use the device near flammable materials.
Do not leave the device or the adapter connected to the outlet unattended.
To provide additional protection, it is advisable to install a residual current device (RCD) with a rated residual current not exceeding 30 mA in the electrical circuit. In this regard, please contact an electrician.
Do not allow the device or adapter to get wet. If the device falls into the water, immediately pull the plug or adapter from the power socket. Do not put your hands into water when the device is connected to the mains. Before re-use, it must be checked by a qualified electrician.
Do not handle the device or adapter with wet hands.
The device should be turned off every time you put it down.
Do not use the device near water, for example: in the shower, in the bathtub or above the basin with water.
If the device uses a power supply, do not cover it, as it could lead to a dangerous increase in temperature and damage to the device. Always, first insert the plug into the power socket in the device and then the power supply to the mains socket.
Do not use the bed sheet in folded condition. Do not put pins, needles and other metal objects in the sheet.
Do not use the sheet if it is wet or damp. Leave the sheet hung loosely in a ventilated area until it is completely dry.
Do not put the power cord on a warmed sheet. Do not fold the equipment when it is placed on top during storage. Check the equipment periodically for signs of wear or damage.
If such signs or equipment are used improperly, please contact your supplier before continuing to use it.
Store in a dry place. Never put heavy objects on the sheet.
Never go to sleep with the electric sheet turned on. Unplug the power plug from the outlet.
Never cover the controller.
Before switching on the electric sheet, make sure that it is evenly distributed, there are no kinks or folds.
Product can be washed in the washing machine in 30°C temperature. Disconnect the power cord and controller before washing. Switch or controller – the regulator must not be wet during washing, and during drying the cord must be in a horizontal position to ensure that the water does not flow into the switch or controller – the regulator.
Do not iron the electric sheet!
This equipment is not intended for medical use in hospitals.
The device should cool down before storage.
The device may be used only with the types of removable elements specified in the equipment marking.
Do not use the device on adjustable beds or if the device is used on an adjustable bed, check that the blanket and cord cannot get stuck or corrugated, eg on hinges.
The device is equipped with a fuse protecting against overheating, which should not work when used in accordance with the intended use of the equipment. If the fuse trips, the device will stop working, the equipment must be returned to the manufacturer or its representative for repair.

Product

Product: Electric blanket underlay CR7416 / CR7417 / CR7423 / CR7424 / CR7421 / CR7422

BEFORE FIRST USE

The product needs to be unfolded and laid flat before switching on.
Fix the product according to instruction in chapter: Fitting your product on the bed.
We recommend that you switch your product to the maximum setting for two to three hours before bedtime then reduce to your desired heat setting 15 minutes before getting into bed. You must switch OFF prior to sleeping.

Fitting your product on the bed

Place the product onto the mattress with the controller (or two) at the HEAD END but towards the foot end of the bed.
The control switches should be below the normal head’s sleeping position.
Unroll the tie tapes and pass the tapes under the bed as shown in the diagrams (Fig.1-6).
Ensure the heating wires do not extend under pillows or hang over the sides. Pass the middle tie tape under the mattress and through the middle loop on the opposite side (Fig.1). Pass end of tape under the corresponding bottom
corner of the mattress (Fig. 2) up through the center loop of product (Fig. 3) and down under opposite corner of

mattress and then through side loop on opposite side of the product (Fig 4).

Repeat this process at the other end (Fig. 5).

DESCRIPTION OF THE DEVICE – electronic controller

Temperature controller
Power cord
Bed sheet / blanket / mat
Socket to disconnect the power cord before washing
Controller display
Switch “ON/OFF”
Heating setting indicator
Time setting indicator
Temperature setting button
Time & continuous operation setting button
Continuous operation indicator “Always on”

OPERATING INSTRUCTIONS – electronic controller With daily use the product will require 15 minutes of preheating before bedtime.
You can program your product to work for 1, 2, 10 hours or continuous operation mode as well as fix temperature choosing 1-8 heat settings.

Plug product into the mains power supply.
Switch on the product with button (6). The product will come at a default setting of 8 heat and operation time 10 hours. The LED for timer (8) and temperature (7) will be illuminated.
By pressing the Heat button (9) you will be able to adjust the temperature of heat settings in range 1-8. The level 1 being lowest heating and the level 8 being highest heating. This will be indicated with the LED.
By pressing the Timer button (10) you will be able to adjust time to turn the product off after a predetermined time being 1, 2, 10 hours or fix the continuous operation mode. This will be indicated with the right LED light.
In order to use the product in continuous mode before you fall asleep, press the Timer button (10) to select the continuous mode “Always on”. This will be indicated by the left LED light.
Switch on the product and unplug after use.

STORING

Always allow the product to cool down before folding and storing. Your product can remain on the bed all year round as a comfortable under-blanket. Simply remove the controls and store until Winter. If you wish to remove the product from your bed when not in use, roll or fold it loosely and store in a bag. Avoid creating sharp creases in the product; for example do not store it under other items that may result in bending the inside heating wires.

CLEANING & AIR DRYING

The product can be machine washed because it is equipped in detachable controllers.
Unplug and remove one or two power cords with controllers from socket (4) to disconnect the power cord before washing.
Fold and presoak the product for 15 minutes in a mild soap and lukewarm water solution. Ensure the water temperature is less than 30°C.

Wash on the delicate or gentle cycle for 2 minutes.
Rinse in fresh lukewarm water.
Gently stretch the product to its original size.
Air dry over a clothes line. DO NOT use clothes pegs or clips of any kind.
DO NOT use the product until it is completely dry !
DO NOT iron the product !

Other Model

Velocity Fan CR 7306
Air Cooler CR 7905
Waffle maker CR 3025
Hair Clipper CR 2821
Portable Cooler CR 93
Lint remover CR 9606
Blender CR 4058
Travel Iron CR 5024
Travel Iron CR 5024
Electric Kettle CR 1239
Food Slicer CR 4702
Bluetooth Speaker CR 1170
Bluetooth Speaker CR 1170
Kettle with temp. control CR 1289
Hair styler set CR 2024
Hair Dryer CR 2255
Steam iron CR 5018
Milk Frother CR 4464
Stand Fan CR 7306
Electric Kettle CR 1169
Air conditioner CR 7907
Turntable CR 1113
Deep Fryer 3L CR 4909
Steam Cleaner CR 7021
Popcorn maker CR 4458
Chocolate Fountain CR 4457
Ash Vacuum 25L 1200W CR 7030
Retro radio CR 1109
Steam Iron CR 5029
Pressure cooker CR 6406
Slow Cooker CR 6410
Super silent vacuum cleaner CR 7037

TECHNICAL DATA

Nominated power input: CR7416 / CR7417 / CR7423 / CR7424 / CR7421 / CR7422 85W / 2 X 60W / 60W / 2 X 60W / 2 X 85W / 85W
Supply voltage: 230 V ~50/60Hz
Dimensions: 150×100 / 150×160 / 150×80 / 150×160 / 160×180 / 160×100

AFTER SALE SERVICE NOTICE

If you want to buy spare parts or make any complaints, please contact the seller who issued the receipt directly.

To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins.
Used appliance should be delivered to the dedicated collecting points due to hazardous components, which may effect the environment. Do not dispose this appliance in the common waste bin.