FALCON RIDGE KAW-4010-WTC01 4010 Windshield Top Combo Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE KAW-4010-WTC01 4010 Windshield Top Combo
Instruction
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of 4010 Windshield / Top Combo
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
- Be sure to read these instructions thoroughly before unrolling and installing the Falcon Ridge 4010 Windshield Top Combo. The installation is best done when the temperature is 65 degrees F. or warmer. This is because the adhesive Velcro works best when warm, if the cab must be installed outdoors in the cold be sure to warm the Velcro strips before installing.
- Carefully unroll the Windshield / Top Combo on a large flat surface that is clean and free of dirt or other materials.
- Check over the parts included in the carton with the parts list shown below:
- Adhesive Velcro Hook strips:
- 6 each ——— 8” long
- “ “ 2 each ——— 6” long
- W/T Combo 1 each
- Loosely drape the Cab Enclosure over the Mule roll cage. Pull the two straps on the front of the nose down and around the bars holding the bumper. Leave loose until you have completed the rest of the installation.
- Working your way to the rear of the roll cage, wrap the bars with the supplied 6” adhesive hook strips. Then stretch the rear of the enclosure over the back and wrap the double-sided strips around the hook strip above the vents, overlapping the ends to provide a secure hold. Be certain to clean the surfaces before applying the adhesive loop strips!
- After attaching the rear of the cab and before attaching the Velcro strips on either side of the windshield it may be necessary to unfasten the front nosepiece and pull it tighter to ensure a good fit.
- Position and install the six (3 per side) 8” hook and loop strips on the left and right sides of the roll cage on either side of the front window. Be certain to clean the surfaces before applying the adhesive loop strips! First, apply all three strips on one side of the roll cage then pull the window tightly toward the other side to minimize waviness or wrinkles in the front window.
Cleaning and Storage Recommendations
- Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag (I recommend a Flannel or Micro Fiber Cloth) or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>