FALCON RIDGE HO-700-TC01 Honda Pioneer 700 Soft Top Cap Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE HO-700-TC01 Honda Pioneer 700 Soft Top Cap
INSTALLATION INSTRUCTION
Notice: Do not smoke inside the cab or expose the enclosure to direct
flames. Cab is Flammable.
Be sure to read these instructions thoroughly before opening and installing
the Honda Pioneer 700 Soft Top Cap. The installation is best done when the
temperature is 70 degrees F. or warmer. The temperature affects the adhesive
Velcro, if conditions prevent installing in warmer weather it helps to store
the adhesive Velcro at room temperature prior to installation.
- Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.
- Check over the parts included in the carton with the parts list shown below:
- Adhesive Velcro Hook Strips 6″ Long 2 each
- Webbing Straps with Velcro 2 each
- Webbing Straps with Loop 2 each
- Webbing Straps with Grommets 2 each
- Begin by wrapping the roll cage with the 6″ adhesive Velcro Strips. In the front wrap the bar about halfway down the bar then wrap the double-sided Velcro strips sewn to the webbing strap around the adhesive Velcro. The strap with Velcro should look like the photo below.
- Next take the other two straps with loop sewn on one end and wrap them around the roll cage on the cross bar. See photo below.
- Now place the top over the entire vehicle, the front of the top is identified by the sides being more steeply curved, and begin by lacing the front straps through the ladder lock buckles sewn to the front corners of the top. Diagram below shows how to use ladder buckle.
- Now run those straps up and through the ladder lock buckles sewn to the rear of the top.
- You now need to tighten and loosen the strap of the top so that it is centered correctly.
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from date item is received. You MUST package the product exactly as it
was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes. Lay all the windows on top of each other with the canvas
folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory new condition to receive refund – a
25% restocking fee will apply. If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors, you must first call them and see
what their return policy is. Once your item reaches our production facility,
our customer satisfaction team will inspect your item to ensure unused,
factory new condition. NOTE: All windshields must be returned with the
original protective film intact and not removed. Do NOT REMOVE if you have any
intentions of returning the item. Refund/ replacement of a windshield will
only be processed on items with original protective film or if the windshield
is defective.
Items must be properly packaged in the original shipping carton to protect
them during transit and ensure your returned item arrives back factory fresh,
and in new resalable condition (any returned items that have been used,
altered or damaged in any way will not be subject for a refund.) All contents
including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will
be approved. Once returned items are received, credit will be issued to the
original credit card/ payment method used for the purchase. Outbound shipping
and return shipping cost will not be refunded. Please allow 4 to 6 weeks for
your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty. 30 Day Warranty which includes and is not limited to
replacing the enclosure, tops and/or windshield due to defects of the product.
Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this
time frame we will gladly correct the problem or replace the enclosure, tops
&/or windshield. Upon submitting for the correction or replacement we will
need to receive pictures of the defect in material or workmanship along with
the receipt from the date of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>