AXAGON ACU-QS24 QC3.0 + 5V-1.2A Wall Charger Instruction Manual
- June 5, 2024
- AXAGON
Table of Contents
AXAGON ACU-QS24 QC3.0 + 5V-1.2A Wall Charger Instruction Manual
SAFETY AND CORRECT HANDLING
– Ensure that the output parameters of the adapter match the parameters of the
powered device.
– Only use good quality and undamaged USB cables.
– Do not cross-connect the charging adapter outputs. Adapter damage may occur!
– Protect the adapter from high temperatures and mechanical damage.
– Use the adapter only in a dry environment
– Protect it from water, do not use with wet hands, there is a risk of
electric shock!
– Do not cover the adapter and allow access to air for sufficient cooling.
-The adapter may become hot during use, it is normal.
– If the adapter is damaged, disconnect it IMMEDIATELY and do not use it
again! – Do not disassemble, modify, or attempt to repair the adapter. – If
you do not use the adapter, unplug it. -The adapter is for indoor use only and
the mains voltage is 100 – 240V –.
– Do not leave the adapter unattended.
TECHNICAL SUPPORT: More information, FAQs, manuals and drivers can be found on
the product page in the
PRODUCT SUPPORT tab at www.axagon.eu. Nothing helped? Write to our technical
support: [email protected].
At the end of its service life, do not throw the product into household waste;
take it to a collection point for electrical equipment recycling. For
information about collection and recycling programmes in your country, contact
your local authorities or the retailer who sold you the product.
EU declaration of conformity: The device complies with the harmonisation
legislation of the European Union 2014/35/EU (LVD), 2014/30/EU (EMC) and
2011/65/EU (RoHS). The complete EU declaration of conformity is available from
the manufacturer.
Before using the product, the user is obliged to read the user instructions.
The manufacturer disclaims any liability for damage that may occur due to
improper use of the product or failure to follow the instructions contained
herein. Product use other than specified must be consulted with the
manufacturer.
Do not use the product in humid or explosive environments and near flammable
substances.
Degree of Protection 20.
The appliance is protected against contact with a finger; the appliance is not
protected against water ingress.
Appliance of protection class II according to IEC 60536 — appliance with
double insulation. The appliance is intended for indoor use in standard
conditions only.