AXAGON SATA M.2 SUPERSPEED USB-C 10 Gbps RAW BOX Instructions
- June 5, 2024
- AXAGON
Table of Contents
SUPERSPEED USB-C 10 Gbps RAW BOX
Instructions
PRODUCT SUPPORT LINK
http://axagon.eu/produkty/eem2-sbc#supportLinkGoal
SuoerSoeed USB 10Gbos external enclosure for SATA M.2 SSD
Mount disk to the box
FIGURE A
CHECK CORRECT INSTALLATION IN THE DEVICE MANAGER
Only devices added to the Device Manager when installing the case and the hard drive are displayed.
FIGURE B
INITIALIZE THE NEW DISK AND FORMAT IT IN DISK MANAGEMENT
SAFE DISCONNECTION OF EXTERNAL BOX
The safest method for removing from the computer is using the Safely Remove Hardware function in the Windows operating system.
OPEN THE BOX
A Slide and remove the back cover.
B Pull out the inside slide. INSERT THE SATA M.2 SSD DISK
FIX THE SATA M.2 SSD DISK
COMPLETE THE BOX
TECHNICAL SPECIFICATIONS
INPUT INTERFACE
USB-C
USB 3.2 Gen 2 • USB 3.2 Gen 1 (USB 3.0)• USB 2.0
10.000 • 5000 • 480 Mbit/s (SuperSpeed+ • SuperSpeed • High Speed) USB Type C
female connector
SUPPORTED DEVICES
SATA (AHCI)
M.2 SSD single or double-sided disks, no disk capacity limitation
M.2 disk dimension support 2242, 2260, 2280 mm
B-KEY AND B+M-KEY M.2 SSD disks supported
NGFF 75-pin 8-key slot for M.2 disks
OTHER FEATURES
Plug and Play & Hot Plug
UASP • TRIM • SSD boot support
The total bandwidth/transmission rate of the box is determined by the used
disk (theoretically up to 650 Mbit/s).
Compliant with Serial ATA 3.1 specification (SATA/600)
Compliant with USB Mass Storage Class specification Supports
BOT (Bulk-Only Transport)
Supports UASP (USB Attached SCSI) for faster data transmission in Windows 8
and later Sleep mode support — after 5 minutes of inactivity, the Aluminum
body helps to cool the M.2 SSD.
POWER SUPPLY
USB bus power
supply via USB 3.0 is fully sufficient in all cases.
LED INDICATION
Decent blue LED indicates USB connection and data transfer
OS SUPPORTED
MS Windows 7/8.1/10 and later
Windows Server 2008 / 2012 / 2016 and later
32- and 64-bit versions supported
Mac OS X 10. x and later
Linux 2.6.x and later
Android (OS and device support needed)
Note: drivers are usually part of OS, no driver installation is needed.
TECHNICAL SUPPORT: More information, FAQs, manuals, and drivers can be
found on the product page in the PRODUCT SUPPORT tab at
www.axagon.eu. Nothing helped? Write to our technical
support: support@axagon.cz.
At the end of its service life, do not throw the product into household
waste; take it to a collection point for electrical equipment recycling. For
information about collection and recycling programs in your country, contact
your local authorities or the retailer who sold you the product.
EU declaration of conformity: The device complies with the harmonization
legislation of the European Union 2014/30/EU (EMC) and 2011/65/EU (RoHS). The
complete EU declaration of conformity is available from the manufacturer.
Before using the product, the user is obliged to read the user’s
instructions. The manufacturer disclaims any liability for damage that may
occur due to improper use of the product or failure to follow the instructions
contained herein. Product use other than specified must be consulted with the
manufacturer.
Do not use the product in humid or explosive environments and near flammable
substances.
(c) 2021 AXAGON
Manufacturer: RealQ s.r.o. – 5, 619 00 Brno,
All rights reserved. All text and pictorial materials contained in this
document are protected by Copyright Act.
All marks indicated here are the registered trademarks of their appropriate
owners.
Specifications are subject to change without prior notice.
Made in CHINA for Axagon.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>